Set-Up · Assembly - Teufel Cinebar 51 THX Technical Specifications And Operating Instructions

Set-up · Assembly
Setting up the speakers
The Cinebar 51 THX System is a high-quality ste-
reo and surround playback set suitable for repro-
ducing film and music sound in rooms up to 30m2.
The sound is automatically in perfect symmetry
with the picture thanks to the satellite speakers
that form an integral part of the Cinebar 51 Unit,
which is attached or set up below or above your
flatscreen TV.
Ě Set-up height should be between 40 centimetres
and 2.0 metres, ideally at ear height to the
sitting position. Your listening position should
be central and in front of the Cinebar 51 Unit.
It also helps to position the Cinebar 51 Unit in
a central position between the two side walls.
When set up correctly, the Cinebar 51 THX System
simulates surround sound realistically, using a
front speaker alone.
You can achieve optimum effects at the following
listening distances, for example:
Ě Room size 10 m2 Listening distance: 1.5 m
Ě Room size 16 m2 Listening distance: 2.1 m
Ě Room size 20 m2 Listening distance: 2.7 m
Optimum distance to
the listening position
Setting up the subwoofer
You can locate the subwoofer anywhere: this will
not affect the other speakers. It is usually benefi-
cial to position the subwoofer near the Cinebar 51
Unit. To adjust the levels between the Cinebar 51
Unit and the subwoofer, please read the relevant
section on page 12.
Assembling the base
The Cinebar 51 Unit can be positioned as a stan-
ding appliance on the base supplied. For optimum
sound, please place the Cinebar 51 Unit right in
the centre, above or below the TV.
Ě Do not place or lean any objects on or against
the Cinebar 51 Unit.
Ě Avoid placing the Cinebar 51 Unit in front of
the TV's remote control receiver.
Cinebar 51 Base
TV base
Wall mounting the Cinebar 51 THX
The Cinebar 51 Unit can be fixed directly to a wall
using the rear bracket. Before doing so, ensure
that the wall is sturdily constructed and capable
of supporting the load! Please use strong screws
in combination with the wall plugs supplied to gu-
arantee a secure hold. For perfect sound, set up
the Cinebar 51 Unit below the TV set.
Please note:
Ě Do not place or lean any objects on or against
the Cinebar 51 Unit.
Ě Attach the connecting cables to the wall to
avoid any possible trip hazards that could cause
the Cinebar 51 Unit to fall.
Ě After assembly, please check that the Cinebar 51
Unit is mounted securely and recheck at
regular intervals. Lautsprecher Teufel accepts
no responsibility for damage caused because
of incorrect assembly.
Each side of the bracket is attached to the
wall using a screw.
Note
If colour changes occur in the
TV picture (e.g. on tube sets),
increase the distance between
the Cinebar 51 Unit and the
TV set until the colour changes
completely disappear. For wall
mounting, please check for
any changes in colour before
assembly.
Note
The positioning illustrated may
not be possible, depending on
the TV set construction.
Using the angle adapter
When wall-mounting the Cinebar
51 Unit, please use the angle
adapters supplied. These ensure
that the cables lie correctly.
Connect the cinch adapter to
the corresponding colour-coded
jacks on the back. The jacks
should always point downwards
(with the exception of any
connections to the TV set).
The optical angle adapter can
be swivelled. This adapter should
also point downwards.
7
· Cinebar 51 THX