Sharp UP-600 Service Manual page 12

Symbol/PartsCod)
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2. UP-600 UTILITY TOOLS
1) OUTLINE
This Specification document describes the explanation about "POSU-
TILITYTOOL.EXE and "02FD.EXE".
"POSUTILITYTOOL.EXE"and "02FD.EXE" works on Windows 95/98
of PC and they have the following
Functions by connecting UP-600 with RS232.
POSUTILITYTOOL.EXE : IPL of UP-600 Program Object
02FD.EXE : All RAM Data Upload/Download
(PC software tool instead of the cur-
rent ER-02FD.)
3) PROCEDURE
3) -1. POS UTILITY
No Procedure on P.C. side
1 Install the "POSUTILITYTOOL.EXE" on the P.C.
6 Connect the P.C. and the UP-600 (CH2) via RS232. (Fig 1)
2) CONNECTION
PC and UP-600 are connected by RS232.
Connect the CH2 port of the UP-600 to the RS-232 interface of the
PC.
PC
D-SUB 9pin - D-SUB 9pin
cable
RS232 Cable Connecting:
[PC]
D-sub 9pin D-sub 9pin
7 7 /RS
4 4 /ER
SD 3 3 SD
1 1 /CD
GND 5 5 GND
RD 2 2 RD
6 6 /DR
8 8 /CS
9 9 /CI
No Procedure on UP-600 side
2 Turn OFF the power.
3 Select "IPL Mode".
Set the "IPL Switch" (SW302) of the UP-600 to "ON".
4 Turn ON the power.
5 Starting of "IPL Mode".
The UP-600 displays
"IPL from Serial I/O"
IPL from Serial I/O
UP-600:CH2
D-SUB 9pin - modular RJ-45
conversion cable
[UP-600]
Moduler RJ45
CI CD
7 1 /RS
4 2 /ER S404
3 3 SD
1 4
5 5 GND
2 6 RD
S403
6 7 /DR
GND
VCC
8 8 /CS
(+5V)
9
(Open)
on off on off
SW302