Onkyo LS3100 Instruction Manual page 18

Adjusting the Subwoofer Level
1 Press SUBWOOFER +/– on the remote
controller.
You can adjust the volume of subwoofer while
listening to an input source. Adjust the volume
by 1 step in the –10 to 10 range. The default is
0.
Muting the controller
You can temporarily mute the output of the
controller.
■
Operating with the remote controller
1
Press .
The output is muted and ON/STANDBY
LED flashes white.
■
Operating on the controller
1
Simultaneously press and hold the
Volume –/+ buttons on the top panel.
Pressing Muting button on your TV remote
controller sets both the controller and the TV
to muting mode. If you press and hold the
Muting button on your TV remote controller
for three seconds again, the controller
changes the setting. This is the function that
adjusts the controller's setting to the TV's
setting by switching the controller's setting
when the controller's setting and TV's
setting of on/off are different.
Tip
• To cancel the muting, press
controller again or simultaneously press the
Volume –/+ buttons on the top panel or change the
volume level.
• Muting is automatically cancelled when the
controller is set to standby mode.
En
18
This function switches between standby mode
and ready mode. When Auto Power On
function is set to on, the controller will enter
ready mode, and when set to off, it will enter
standby mode. In ready mode, the controller
will be automatically turned on in conjunction
with audio input from the TV and TV selector
will be selected.
1
2
3
Default: Ready (North American models),
Standby (European and Australian models)
• If you don't want the controller to be turned on
on the remote
• When the controller is in ready mode with Auto
• When entering the ready mode with the Bluetooth
Setting the Auto Power On
Turn off the controller.
Press and hold ON/STANDBY on the
top panel for three seconds.
The controller enters ready mode and
ON/STANDBY LED flashes amber
indicating that the setting is completed.
Press and hold ON/STANDBY on the
top panel for three seconds again to turn
the Auto Power On function "off".
The controller automatically enters
standby mode and the ON/STANDBY
LED goes off.
If you operate the controller with your TV
remote controller, set the Auto Power On
function to on. The controller cannot be
turned on by using Power On button on your
TV remote controller.
Note
automatically when the TV is on, set the Auto
Power On function to off.
Power On function "on", the controller will be
turned on by receiving the audio input from the TV.
selector selected, the controller might be turned on
by selecting the TV selector automatically by
receiving the audio input from the TV.