Samsung 5 Series User Manual page 26

After you have run the initial setup, you can
1V's menu.
Configuring a Wireless Network Connection
The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP) to
configure network connections
network, see the e-Manual
To configure the network connection
1. Connect your 1V to your network as shown
2. Turn on your 1V, and then go to the Network Settings screen.
Settings)
3. Select Start. The Network function searches for available
list of the available networks.
4. In the list of networks, move the
~
If you have a WPS(PBC)
directions on the screen.
5. Enter your network security key
~
Enter numbers and
• Enter numbers by pressing the number buttons on your remote.
• To enter a letter,
the same fashion
~
To display capital letters
Shift.
~
To display symbols and punctuation, select
6. When done, select Next
7. The 1V checks the wireless
Internet. If you have any problems using online services, please contact your Internet Service
Provider." message appears.
~
For more detailed information,
~
If you want to configure
screen. Set IP Mode
manually.
DNS Server
Configuring Network Connections
configure or reconfigure the network
automatically. Most wireless networks use DHCP. If you have a Static
for configuration instructions.
for a network that uses DHCP, follow these steps:
in the illustration
highlight to select
compatible router, select
or WPS PIN using your
letters using your remote.
move the Highlight to the letter, and then select it.
way if you choose.
(or redisplay small letters if
*·
if you have entered a security
connection. If the connection
Select Next using your
see "Setting up
the connection manually, select
to Manual, and then enter
connections
on page 14.
(Menu----> Network----> Network
wireless networks. When
a network, and then select
WPS(PBC) instead, and
remote.
You can enter
capital letters are displayed), select
To redisplay letters, select
key or WPS PIN if you
is successful , the "You are connected to the
remote.
a Wireless Network" in the
on the Network Connection
IP Settings
the IP Address, Subnet Mask, Gateway,
through the
IP
done, it displays a
Next.
then follow the
numbers in
Caps or
*
again.
have entered a WPS PIN .
e-Manual.
and