Yamaha PianoCraft MCR-940 Owner's Manual page 51

Problem
Disc playback does You may use a recordable disc that is not
not start. finalized.
The disc label may not be facing up.
The disc may be defective.
The disc is dirty.
The region code on the disc does not
match that of the BD player.
If the recorded time of a disc is unusually
short, playback may not be possible.
BD-RE/R discs recorded in a format
other than BDMV cannot be played back.
Video playback Excessive force or vibration was applied
stops.
to the BD player.
The BD player is not placed on a steady
flat surface.
The BD player makes The BD player has not been operated for
a snapping noise
a while.
when a disc is loaded
or played.
There is no picture. The video cable is not connected properly
to your TV.
The input setting on your TV is not
correct.
The BD player is not set properly for
HDMI or component video cable
connection.
The screen freezes The disc is damaged or dirty.
and operation
The BD player is frozen.
buttons do not work.
There is sound but The video cable is not connected
no picture.
properly.
An image is not The video output resolution setting does
output with the
not match the resolution of the TV
desired resolution. connected to the BD player.
"Video Out Select" is not set properly.
"Component Video Out" or "HDMI
Video Out" is not set to the desired
resolution.
Widescreen images "TV Aspect Ratio" is not set properly for
look vertically the connected TV.
stretched, or black
A 4:3 standard TV is connected but
bands appear at the
"Video Out Select" is not set to
top and bottom of the
"Component".
screen.
4:3 images look
horizontally
stretched.
Cause
Finalize the recordable disc.
Place the disc in the disc tray with the label facing
up.
Try to play back another disc. If the same problem
does not occur, the disc you want to play back is
defective.
Clean the disc surface.
Use a disc with the same region code as the BD
player.
Do not apply excessive force or vibration to the BD
player.
Place the BD player on a steady flat surface.
This may happen if it has not been operated for a
while. This is not a malfunction.
Connect the video cable properly to the TV.
Select the correct input setting on the TV.
Set the BD player properly.
Check the disc surface.
Reboot the BD player.
Connect the cable properly.
Perform "VIDEO RESET".
Switch between "HDMI" and "Component" by using
"Video Out Select" or "HDMI <-> COMP".
Set "Video Out Select" properly.
Set "Component Video Out" or "HDMI Video Out"
to the desired resolution.
Set "TV Aspect Ratio" properly for the connected
TV.
When a widescreen TV is connected, set "TV Aspect
Ratio" to "Wide 16:9".
When a 4:3 standard TV is connected, set "Video
Out Select" to "Component".
When a 4:3 TV is connected, set "Video Out Select"
to "Component".
TROUBLESHOOTING
Remedy
See
page
—
—
—
53
3
—
—
—
9
13
37
—
5
9
45
37, 45
37
37
37
37
37
49
En