Kenwood DNX7210BT Quick Start Manual page 29

Connecting wires to terminals (2)
Connect to the vehicle's
parking brake detection
switch harness.
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not
supplied) matched to your car.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To use the Mute feature, you need to hook up this
wire to your telephone by using a commercial
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna,
or to the power terminal for the booster amplifier
of the film-type antenna. (Max. 300mA, 12V)
If no connections are made,
do not let the cable come out from the tab.
DNX7210BT/DNX5210BT/DNX5510BT/DNX4210BT
Light Green (Parking sensor wire)
For best safety, be sure to connect the
parking sensor.
Purple/White (Reverse sensor wire)
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
Light Blue/Yellow
(Steering remote control wire)
To steering remote
Brown (Mute control wire)
telephone accessory.
Blue/White (Power control/
Antenna control wire)
29
Accessory 1
PRK SW
REVERSE
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
MUTE
ANT.
P. CONT
CONT