Setting Up Your Digital Box With A Scart Cable - Matsui Freeview TV receiver User Manual

Setting up your Digital Box with a SCART cable

You need a SCART socket on your TV to connect this
product.
SCART connections offer the best picture and sound quality.
They can also tell your TV when the Digital Box is switched
on and off and whether widescreen pictures are being
broadcast.
Before you begin, make sure you have easy access to the
connectors on your TV and any other connected equipment.
1 Unpack the Box
• Unpack the Box and check that there are no parts missing.
• Choose a suitable location for the Digital Box. Make sure it
will have sufficient ventilation and is not exposed to direct
sunlight, heat, humidity or water. Make sure you can 'see'
it with the remote control.
2 Insert remote control batteries
• Open the remote control battery compartment - on the
under-side of the remote control.
• Insert the AA batteries supplied in the direction indicated
inside the compartment.
3 Connect your aerial to the Digital Box
• Make sure your TV is switched off, together with any other
equipment you are connecting to.
• Insert the cable from your aerial into the Digital Box
socket marked 'AERIAL'.
6
From your
roof aerial
4 Connect the SCART cable
Choose the option below that best suits your TV (and VCR, if
you have one). If you need a longer SCART cable, you can
find one at most TV or electronics retailers.
Option 1: connecting to a TV only
• Connect the SCART cable between the 'TV' socket on your
Digital Box's rear panel and your TV's SCART socket.
• Connect the RF cable between the 'RF OUT' output on the
Digital Box and the RF socket on your TV (where you
normally connect the aerial).
The connector with
a slot in the end
goes to your TV,
the other end goes
into the box
From your
To your TV
roof aerial
To your TV