Country Hearth 2000 Owner's Operation And Instruction Manual
Us environmental protection agency phase ii certified woodstove
Hide thumbs
Also See for 2000:
- Owner's operation and instruction manual (21 pages) ,
- Owner's operation and instruction manual (25 pages) ,
- Owner's operation and instruction manual (13 pages)
Table of Contents
Advertisement
For service questions, contact US Stove at 1-800-750-2723.
For sales inquiries, contact Sylvane at 1-800-934-9194 or visit www.sylvane.com.
Owner's Operation and Instruction Manual
Please read this entire manual before you
install or use your new room heater.
to follow instructions may result in property
damage, bodily injury, or even death.
Improper Installation Could Void
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU
TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
S
C
U
S
MODELS: 2000(L)(LN), 2500(L)(LN)
SAFETY TESTED TO UL 1482 and ULC-S627
US ENVIRONMENTAL PROTECTION AGENCY PHASE II CERTIFIED WOODSTOVE
WASHINGTON STATE APPROVED
MOBILE HOME APPROVED (U.S. ONLY)
CAUTION!
Your Warranty!
SAVE THESE INSTRUCTIONS
United States Stove Company
SAFETY NOTICE:
If this heater is not properly installed, a house
Failure
fire may result. For your safety, follow the in-
stallation instructions. Never use make-shift
compromises during the installation of this
heater. Contact local building or fire officials
about permits, restrictions and installation
requirements in your area.
227 Industrial Park Road
P.O. Box 151
South Pittsburg, TN 37380
TESTED &
PORTLAND,
LISTED BY
OREGON, USA
2000 Report #: 215-S-29-2
2500 Report #: 215-S-23-2
851710 rev C
Advertisement
Table of Contents
Related Manuals for Country Hearth 2000
Summary of Contents for Country Hearth 2000
- Page 1 TO ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. United States Stove Company TESTED & PORTLAND, 227 Industrial Park Road LISTED BY OREGON, USA P.O. Box 151 2000 Report #: 215-S-29-2 South Pittsburg, TN 37380 2500 Report #: 215-S-23-2 851710 rev C...
-
Page 2: Specifications
Minimum Chimney Hieght : 12’ (3.7m) Maximum Log Length : 21” (533.5mm) Dimensions ” Overall : 2000 ” x 27” x 28 (521mm x 686mm x 727mm) Depth x Width x Height : ” 2500 25” x 27” x 28 (635mm x 686mm x 727mm) ”... - Page 3 WARRANTY INFORMATION CARD Name__________________________________________ Telephone #: (_____)_____________ City____________________________________________ State_______ Zip_________________ Email Address __________________________________________________________________ Model # of Unit________________________________ Serial #___________________________ Fuel Type: qWood qOther _________________________ qCoal qPellet qGas Place of Purchase (Retailer)______________________________________________________ City____________________________________________ State_______ Zip_________________ If internet purchase, please list website address___________________________________ Date of Purchase _______________________________________________________________ Reason for Purchase: qAlternative Heat...
- Page 4 Ê É Fold Here Fold Here Fold Here PlACE STAMP HERE United States Stove Company P.O. Box 151 South Pittsburg, TN 37380 Ussc...
-
Page 5: Assembly
1. Locate the Room Air Deflector. Using the three(3) 1/2 Tek Screws provided, mount the deflector to the unit as shown in the diagram. Firebrick Configuration: 1. Replace the Firebrick as shown in the illustration below. Side view of flue collar 5/16-18 x 1-1/2 mount to heater top BOLT HEATER WELD Brick Configuration 2000 2500 Ussc... -
Page 6: Assembly Instructions
ASSEMBLY INSTRUCTIONS Blower Assembly THE BLOWER ASSEMBLY MUST BE DISCONNECTED FROM THE SOURCE OF ELECTRICAL SUPPLY BEFORE ATTEMPTING THE INSTALLATION. THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY WITH A STOVE THAT IS MARKED TO INDICATE SUCH USE. DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS HOT SURFACES! Step 1. -
Page 7: Installation
INSTALLATION SAFETY NOTICE • IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. • CONSULT YOUR MUNICIPAL BUILDING DEPARTMENT OR FIRE OFFICIALS ABOUT PERMITS, RESTRICTIONS AND INSTALLATIONS REQUIREMENTS IN YOUR AREA. •... -
Page 8: Floor Protector
Total R = Rbrick + Rmineral = 0.8 + 0.431 = 1.231 Total R is greater than 1.2, the system is acceptable. The floor protector should exceed the stove as follows: Model Front Sides Rear 2000 25” 8” ¶6” (635mm) (203mm) (152mm) 2500 26”... -
Page 9: Clearances To Combustibles
CLEARANCES TO COMBUSTIBLES It is of utmost importance that the clearances to combustible materials be strictly adhered to during installation of the stove. Refer to the tables below : Single Wall Pipe (Double Wall Pipe) Model A 2000 20(14) 22(20) 22.5(16.5) 32(30) -
Page 10: Chimney Connector (Stove Pipe)
CHIMNEY CONNECTOR (STOVE PIPE) Your chimney connector and chimney must have the same diameter as the stove outlet (6”). If this is not the case, we recommend you contact your dealer in order to insure there will be no problem with the draft. - Page 11 CHIMNEY Your wood stove may be hooked up with a 6” factory built or masonry chimney. If you are using a fac- tory built chimney, it must comply with UL 103 or CSA-B365 standard; therefore it must be a Type HT (2100°F).
-
Page 12: Factory Built Chimney
FACTORY BUILT CHIMNEY : When a metal prefabricated chimney is used, the manufacturer’s installation instructions must be followed. You must also purchase (from the same manufacturer) and install the ceiling support package or wall pass-through and “T” section package, firestops (where needed), insulation shield, roof flashing, chimney cap, etc. -
Page 13: Masonry Chimney
MASONRY CHIMNEY : Ensure that a masonry chimney meets the minimum standards of the National Fire Protection As- sociation (NFPA) by having it inspected by a professional. Make sure there are no cracks, loose mortar or other signs of deterioration and blockage. Have the chimney cleaned before the stove is installed and operated. - Page 14 Combustible Wall Chimney Connector Pass-Throughs Method A. 12” (304.8 mm) Clearance to Combustible Wall Mem- ber: Using a minimum thickness 3.5” (89 mm) brick and a 5/8” (15.9 mm) minimum wall thickness clay liner, construct a wall pass- through. The clay liner must conform to ASTM C315 (Standard Specification for Clay Fire Linings) or its equivalent.
-
Page 15: Outside Combustion Air
OUTSIDE COMBUSTION AIR Your wood stove is approved to be installed with an outside air intake which is necessary for a mobile home. This type of installation is also required in air tight houses and houses with negative pressure problems. You can purchase this option through your heater dealer. Make sure to specify the part number mentioned in this booklet. -
Page 16: Testing Your Wood
WOODSTOVE UTILIZATION Your heating unit was designed to burn wood only; no other materials should be burned. Waste and other flammable materials should not be burned in your stove. Any type of wood may be used in your stove, but specific varieties have better energy yields than others. -
Page 17: The First Fires
When you have achieved a good bed of hot embers, we recommend the following burn procedures: 2000 Primary Air Settings... -
Page 18: To Prevent Creosote Build Up
WARNINGS • NEVER OVERFIRE YOUR STOVE. IF ANY PART OF THE STOVE STARTS TO GLOW RED, OVER FIRING IS HAPPENING. READJUST THE AIR INTAKE CONTROL AT A LOWER SETTING. • THE INSTALLATION OF A LOG CRADLE or GRATES IS NOT RECOMMENDED IN YOUR WOOD STOVE. -
Page 19: Ash Disposal
ASH DISPOSAL Ashes should be removed from the stove every few days or when ashes get to 2 to 3 inches deep. Always empty the stove when it is cold, such as in the morning. Ashes should be placed in a metal container with a tight fitting lid. -
Page 20: Parts List & View
REPAIR PARTS 32 33 Feed Door Assembly Ussc... - Page 21 5/16-18 x 3/4 Hex Head Bolt 891530 Firebrick (4-1/2 x 7-1/2 ) 83338 5/16-18 Lock Nut 40561 Ash Plug 891373 Door Hinge Pad 891777 2000 Pedestal Wrapper 83045A Washer, 3/8” ID x 7/8” OD 891788 2500 83274 3/8-16 Lock Nut 891778 2000...
- Page 22 NOTES Ussc...
- Page 23 NOTES Ussc...
- Page 24 For service questions, contact US Stove at 1-800-750-2723. For sales inquiries, contact Sylvane at 1-800-934-9194 or visit www.sylvane.com. HOW TO ORDER REPAIR PARTS THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM YOUR HEATER, AND ENABLE YOU TO ORDER REPAIR PARTS COR- RECTLY.
Need help?
Do you have a question about the 2000 and is the answer not in the manual?
Questions and answers
I **** looking to replace the gaskets on the door and glass i found some on line but there are different thickness can you tell the size that on this model thanks