Front Panel; Digital Pod A / Digital Pod - LeCroy ArbStudio Manual

Front Panel

Numbered callouts on this image correspond with the following descriptions.
Figure 3‐1. This is an image of the ArbStudio 1104 model and therefore has a POD B connector and two additional
Channel Outputs. Although digital pods appear on all models, they are only active on 1102D and 1104D models.
DIGITAL POD A / DIGITAL POD B
1. DIGITAL POD A / DIGITAL POD B
• Pod A and Pod B – Digital probe connectors.
Note: DIGITAL POD B is only available on ArbStudio 1104. POD A and POD B are only active on
1102D and 1104D models. ArbStudio 1102 and 1104 can be upgraded to include the digital
pattern generator.
2. EXT CLK
• EXT CLK In ‐ BNC input connector for external clock.
3. TRIGGER
• Trigger Out ‐ BNC output connector for Trigger OUT.
• Trigger In ‐ BNC input connector for Trigger IN.
4. ANALOG OUTPUTS
• Ch1, Ch2, Ch3, Ch4 ‐ Open ‐12V to 12V, ‐6 to 6V on 50 Ω Load.
Note: Ch3 and Ch4 are only available on ArbStudio 1104 and 1104D models.
5. STATUS LED
Indicates instrument power status.
6. POWER‐ON LED
Indicates the power status of the instrument. The status led can be OFF, ON, or Blinking denoting the
following conditions:
OFF
The instrument is ON and connected to a PC, but drivers have not been installed.
ON
The instrument is ON, connected to a PC, and correctly configured.
B
LINKING
The status led is Blinking when the ArbStudio 1102/1104 is uploading firmware for channels.
918221 RevA
Getting Started Manual
11