Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW Instruction Manual page 14

FOLDING THE STAND (FIG. B, C, F)
1. Raise the cover plate (4) on the right side of stand,
pull the locking handle (5) out, and then move the
saw close to the wheel (6). (Fig. C, F)
2. Rotate the hook (1) to the stop screw to
secure the legs of the stand in position. (Fig. B)
3. Rest the right side of the saw onto the floor.
4. Fold the left side leg set (3) close to the base by
releasing the two left side locking levers (2) from slot
B to slot A.
5. Fold the stand slowly downward as shown. (Fig. F)
TRANSPORTING THE SAW (FIG. B, C, F)
1. Raise the cover plate (4) on the right side of stand,
pull the locking handle (5) out, and then move the
saw close to the wheel (6). (Fig. C, F)
2. Rotate the hook (1) to the stop screw to
secure the legs of the stand in position. (Fig. B)
3. Rest the right side of the saw onto the floor.
4. Unfold the left side leg set (3) by releasing the two
left side locking levers (2) from slot B to slot C.(Fig.B)
5. Move the saw to the desired location for operation or
store the saw in a dry environment by using the left
side leg set (3) as handle.
Fig. F
1
UNFOLDING THE STAND (FIG. B, C, D)
Please refer to the section "SETTING UP THE STAND"
on page 13.
STORAGE (FIG. G, H, I, J, K, L)
INSTALLING THE BLADE GUARD, ANTI-KICKBACK
PAWLS AND RIVING KNIFE STORAGE (FIG. G)
1. Bag " E "
_ Attach the retaining clip (1) to the stand
(2) using screws (3) and tighten screws securely.
2. Attach the set plate (4) to the stand (2) using
hex. bolts (3) and tighten hex. bolts securely. Thread
the knob (5) to the bottom of the set plate (4).
INSTALLING THE PUSH-STICK STORAGE HOLDER
(FIG. G)
_
Bag " E "
Attach the metal push-stick storage bracket
(6) into the provided slots on the right side of the stand.
The bracket will snap into place.
1
1
folding
1
1
transporting
Fig. G
3
4
1
5
Rip fence, miter gauge (Fig. H)
Storage brackets for the rip fence (1) and miter gauge
(2) are located on the left side of the saw housing.
Fig. H
1
2
Blade/blade wrench (Fig. I)
1. Loosen and remove the knob (1) on the right side of
the saw housing.
2. Place blade wrenches (2), extra blades (not
included), onto the arbor. Replace the knob and
tighten.
Fig. I
2
1
14
2
3
6