2N EasyRoute User Manual page 39

Replace '+'
If this parameter is enabled, the '+' character is replaced with the defined string
in the international prefix of the CLI. It is because the '+' character can neither be
transmitted by the FSK protocol nor dialled in the DTMF format from a terminal.
Setting options:
Default setting:
Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
Signalling
Pulse frequency
Set the tariff pulse frequency.
Setting options:
Default setting:
Tariff pulse at call beginning
Enable/disable tariff pulse sending when the call begins. The pulse is sent when
the call is answered in the GSM network.
Setting options:
Default setting:
Tariff pulse at call end
Enable/disable tariff pulse sending when the call ends. The pulse is sent when the
call is hung up in the GSM network.
Setting options:
Default setting:
Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
Advanced
Enable receive path high pass filter
Enable/disable the high pass filter for the signal receive path.
Setting options:
Default setting:
Table of Programmable Parameters
0–15 characters (0–9, *, #)
Empty
12/16 kHz
12 kHz
Enabled/Disabled
Disabled
Enabled/Disabled
Disabled
ON/OFF
ON
ER
ER
39