Husqvarna Rider Pro 15 Workshop Manual page 25

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
2
Position the pulley with tool no. 506 56 76-01 and
tighten it with moment (80 Nm). Use tool no. 506 89
92-01 as a holder-on.
3
Place the wires in the wire holder. Make sure that
the hydrostatic transmission wire is at the bottom.
Clamp together the holder and bring it from
underneath through the centre of the belt tensioner
until it hooks over the top edge of the tensioner.
4
Hook the choke wire onto the carburettor and fit the
wire clamp without tightening it.
Push the choke control to full choke position. Pull
wire's outer casing as far as possible to the right
and tighten the wire clamp. The picture shows Pro
15 and ProFlex 18. For ProFlex 21, see "Replacing
engine".
24
– Svenska
506 56 76-01
www.mymowerparts.com
5
Hook the throttle wire onto the carburettor and fit
the wire clamp without tightening it. Make sure it is
hooked into the right hole on Pro 15 and ProFlex
18, see picture. Push the throttle control to full
throttle position. Pull the wire's outer casing as far
as possible to the left and tighten the wire clamp.
For a picture of ProFlex 21, see "Replacing engine".
6
Attach the silencer and exhaust pipe and tighten
the holder screws and pipe clamps.