External Control - JVC IF-2D3D1 Instructions Manual

3d image processor
Table of Contents

Advertisement

External control

You can control the unit using a PC or the special control unit connected to the RS-232C terminal on the rear of
the unit.
Connect the RS-232C straight-through cable (purchased separately) to the RS-232C terminal on the rear of the unit. (See page ii.)
Control specifications
Communication specifications
Baud rate:
Data bits:
Parity:
Terminal specifications
This is a male
terminal.
Connection
1
Connect the PC to the RS-232C terminal on the rear of the unit using an RS-232C extension cable (purchased separately).
2
Send the log in command from the PC to log into the unit.
REMOTE MODE appears on the information display and the unit becomes operatable from the PC. You cannot operate the unit
using the buttons while the PC is logged into it.
R E M
O
T E
When the operation has finished, send the log off command to the unit from the PC to log off.
If you cannot log off the unit from the PC, press and hold
the unit remain locked after the forcible shutting down. Press and hold
Communication is automatically terminated if the unit is turned off during communication. Log in from the PC again to
restart external control.
Command outline
You can control the unit by sending commands from an external device.
Communication example
External control
device
Command structure
! 00BCN1000Cr
a b
18
EN
9600bps
8 bits
Odd parity
Pin number
1
2
3
4
5
6
7
8
9
M
O
D
E
1
!00BCN1000Cr
3
2
@00BOK.000Cr
c
d e
b:
d:
Stop bits:
Flow control:
Communication code: ASCII code
Signal
RXD
TXD
GND
and
. Communication is forcibly terminated. The buttons on
and
IF-2D3D1
a:
Header
! : Control command from an external device
? : Reference command from an external device
@ : Response command from the unit
Device ID
00 (Fixed)
c:
Command
Command list (see page 19)
Data
e:
Exit code
Cr (0Dh)
1 bits
None
again to release the lock. (See page 17.)
1 Command for starting
communication
2 Acceptance from the unit
3 The unit becomes operatable
from the external control device.

Advertisement

Table of Contents
loading

Table of Contents