Page 2
® ™ Welcome to the world of iRobot. As an owner of the iRobot Braava Floor Mopping Robot, you join a growing group of people around the globe who, like you, are discovering an easier way to mop their floors.
• Move any power cords as well as cords for blinds and curtains out of the way to reduce the risk of objects being pulled down. • Block off access to open balconies near the cleaning area with physical barriers. Braava 300 Series Owner’s Manual...
2. This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications not expressly approved by iRobot could void your warranty. This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.
Navigation Sensor ® Navigation System Indicator Bumper Handle Cube on/off button (on back corner) Removable Cleaning Pad NorthStar Navigation Cube ® Battery Charging Port Floor Transition Sensors Wheel Guards Charging Adapter Turbo Charge Cradle (380t) Braava 300 Series Owner’s Manual...
Page 7
For dry sweeping or wet mopping, disposable or reusable microfiber cloths. Cloth Gripping Strips Middle Channel for Floor Transition Sensors Pro-Clean Reservoir Pad (Ships with Select Models) For wet mopping with the blue Pro-Clean microfiber cleaning cloth. Fill Cap Reservoir Wick global.irobot.com...
Press once to start cleaning.* Press while cleaning to pause. Blue solid light: Mop mode activated Blue blinking light: Mop mode paused *Holding the cleaning mode button will activate Quick Clean Mode. See page 15. Braava 300 Series Owner’s Manual...
Page 9
Blue lights flashing with pause: Sleep mode Red light in middle: Error* See trouble shooting section for more information. NorthStar Navigation Cube Lights ® Blue blinking light: Power on, broadcasting signal Blue solid light: Power on, connected to Braava Red solid light: Batteries low global.irobot.com...
CAUTION: Do not charge Braava while the Pro-Clean reservoir pad or any wet cloth is attached. Charge using a standard 120V outlet only. Only use the included adapter to charge Braava. Always disconnect Braava from the adapter before cleaning. Braava 300 Series Owner’s Manual...
The Cube uses 2 C batteries. The battery door can be found on the bottom of the Cube. Power Button Red pulsing light: Battery charging Blue solid light: Battery charged Please dispose of all batteries properly by finding a recycling resource near you. global.irobot.com...
Mop mode to optimize cleaning while the cloth is wet. TIP: Start with dry Sweep mode to pick up surface grit and then follow with a wet cloth in mopping mode to get a deeper clean. Braava 300 Series Owner’s Manual...
NOTICE: Braava is not intended to pick up large debris. Before cleaning with Braava, pick up large debris and check for gravel or sharp objects that could scratch the floor if captured under the cleaning pad. global.irobot.com...
Braava a boundary it can detect. • Braava follows along walls and edges as it encounters them and as it completes each section it cleans. Braava 300 Series Owner’s Manual...
• To exit Pause and quit the cleaning cycle, power Braava off by holding the power button for 2 seconds. Note: Braava can only be paused after it has locked onto the NorthStar Navigation Cube at the beginning of the cleaning cycle. global.irobot.com...
350 square feet to optimize for cloth wetness. Mode Braava 320 Braava 380t Coverage Sweep 800 sq. ft. 1,000 sq. ft. 250 sq. ft. 350 sq. ft. up to 2,000 sq. ft. with additional NorthStar Cube (sold separately) ® Braava 300 Series Owner’s Manual...
Page 17
• Braava will automatically clean from one Cube to another. Cubes are pre-programmed to different NorthStar channels, indicated on the bottom of the Cube. Cubes with different channels must be used for multi-Cube cleaning. 25’ One Cube Multiple Cubes global.irobot.com...
Re-attach the cleaning pad. Magnets will help it snap back into place. CAUTION: Make sure the cleaning cloth does not drape into the middle channel between the gripping strips as this could impede sensor functions and safe operation. Braava 300 Series Owner’s Manual...
When mopping is finished: • Empty any remaining fluid from the reservoir. • Leave the fill cap open to allow reservoir to dry completely. Do not store the pad on Braava if wet. • See page 22 for care instructions. global.irobot.com...
Page 20
• Do not move the NorthStar Navigation Cube once Braava has started cleaning as it may impair Braava’s cleaning performance. • Do not put the NorthStar Navigation Cube on the floor as the cleaner may run into it and move it. Braava 300 Series Owner’s Manual...
• To turn Braava off, press the power button for two seconds. A tune will play and the light will turn off. • To turn off the NorthStar Navigation Cube, press the button on the back corner. The light on the opposite corner will turn off. global.irobot.com...
• Periodically check Braava’s wheels to see if debris has accumulated and remove as needed. • A small notch next to the wheel allows access with tweezers or scissors if needed to free the debris. Access Notch Braava 300 Series Owner’s Manual...
Page 23
• If the wick cap becomes dirty or shows wear, it can be replaced. • Remove the wick cap by pulling on the side rubber tab. • Replace with a new wick cap, pressing firmly into place to create a tight seal to prevent leaking. global.irobot.com...
Trouble Shooting Visit global.irobot.com for additional tips and trouble shooting. Navigation System Indicators (NSI) Error Indicators on the Navigation System Indicator (NSI) while cleaning Problem: Likely Cause What To Do Solid red light on System error • Press and hold the power button to turn Braava off.
Page 25
Check the fill cap and the wick cap and make sure both are puddles. securely sealed shut. Fluid will dispense at a faster rate if these caps are not sealed. Not wicking fluid. Wick cap requires Refer to Reservoir Pad maintenance for instructions to replacement replace the wick cap. global.irobot.com...
If problem persists, contact Customer Support. Battery needs Charge Braava for 12 hours using the adapter and not a refresh charge Cradle, then run Braava until battery fully depletes. Repeat 3 times to achieve expected run times. Braava 300 Series Owner’s Manual...
USA & Canada If you have questions or comments about this product please contact iRobot before contacting a retailer. Please visit the iRobot home support site at www.irobot.com/support for support tips, frequently asked questions, or information about accessories and other iRobot products.
Need help?
Do you have a question about the Braava 300 series and is the answer not in the manual?
Questions and answers