Port Configuration - Dell PowerConnect 5224 System User's Manual

boot system {boot-rom| config |
opcode}: filename
Example
Console#copy tftp startup-config
TFTP server ip address: 10.1.0.99
Source configuration file name: startup.01
Startup configuration file name [startup]:
/
Console#
Reset
Click Reset to reboot the switch. When prompted, confirm that you want to reset the switch.
CLI Commands
The following table summarizes the equivalent CLI command for items in the Switch/Reset page.
Command
reload
Example
Console#reload
System will be restarted, continue <y/n>? y
Console#
Ports
The Port Manager contains links to the following options:

Port Configuration

l
Trunk Configuration
l
Broadcast Control
l
Port Mirroring
l
Port Configuration
On the Port Configuration page, you can view and edit port parameters. For each port number listed in the Port column, you can change the following
parameters listed by column name on the screen:
Name/Type — Allows a user-defined label for the port and indicates the type of port:
l
1000Base-TX — 10/100/1000Base-T RJ-45 port
¡
1000Base-SFP — gigabit SFP transceiver port
¡
Admin/Oper — Allows the network administrator to manually disable a port and indicates the status of the link: up or down.
l
Speed/Duplex Mode — Allows the manual selection of port speed and duplex mode and indicates the current port speed and mode.
l
Specifies the file or image used to start up the system
Usage
Restarts the system