Table of Contents
Advertisement
Path Status and Examples of Recovery Procedure (SVS200)
This section describes errors that require recovery operation on the external
storage system side when the path status is not normal. When the path status
is not normal, see the following table to recover the path status. If you cannot
restore the path, call the Hitachi Data Systems Support Center (see
Hitachi Data Systems Support
Table A-13
Path Status
External device
setting changed
Illegal request or
Response error
Cannot detect port
A-14
Hitachi Universal Storage Platform V/VM Universal Volume Manager User's Guide
Center).
Path Status and Examples of Recovery Procedure (SVS200)
Settings of the LU paths may have been changed by LUN Management. Check
the settings of the LU paths. If the settings of the LU paths have been changed,
change the settings back to the ones when the volume is mapped. Or use
Universal Volume Manager to perform the Delete LU operation and perform the
Add LU operation again.
The access attribute of the volume may have been changed by LUN Security XP
Extension. Check the access attribute of the volume. If the volume is protected
by the access attribute, release the protection.
The volume may have been set as a pair volume for data copy. Check if the
volume is set as a pair volume of Business Copy XP, Continuous Access XP,
Continuous Access XP - Journal, or some other copy program. If the volume is
set as a pair volume, the volume may be protected because of the pair status.
When the volume is protected, change the pair status or delete the pair.
The access attribute of the volume may have been changed by LUN Security XP
Extension.
Check the access attribute of the volume. If the volume is protected by the
access attribute, release the protection.
There is a problem with connection to the external storage system. The possible
causes are:
The fibre cable is not physically connected in the proper way.
The setting of the topology does not match between the external port and
the target port.
If the external storage system is connected through switches, the settings
for the switches may not be appropriate.
Make sure that the fibre cable is connected properly, and then set the fibre
channel port properly using LUN Management.
The LUN security may have been enabled by LUN Management. Check if the
LUN security is enabled or not. If the LUN security is enabled, disable the LUN
security.
Connecting External Storage Systems
Examples of Recovery Procedure
Calling the
Advertisement
Table of Contents
