Panasonic Easa-Phone VA-824 Installation And Programming Manual page 30

Read the following paragraphs before proceeding to the actual programming instructions and procedures.
These notes and procedures are intended to acclimate the programmer to the proper programmingsequencerequired prior to
the actual programming.
0
Programming of initial set
@ Assure that the RAM switch is posi-
tioned at "CLR" side.
@ Set the power switch to the "ON"
position.
@ After about 5 seconds, assure that the
DATA MONIT lamps is flashing.
@ Change the RAM switch from the
"CLR" side to "HOLD" side.
The initial set programming is now com-
pleted through the above operations.
NOTE
If you change the programming again,
the RAM switch is not necessary
switched over.
2. METHOD OF PROGRAMMING
27