Section 4. Programming; Introduction; Time And Set-Point Programming - Henny Penny PRESSURE FRYERS 500 Operator's Manual

4-1. INTRODUCTION

4-2 TIME AND SET-POINT
PROGRAMMING
4-1

SECTION 4. PROGRAMMING

The controls are preset from the factory, but desired functions can
be programmed in the field. This section includes programming
product times and set-points, and Special Programming, which are
the more detailed settings.
If "LOCK" shows in the display when trying to change the
set-points or times, the controls must be unlocked before making
changes. See Special Programming for unlocking procedures.
To Change Set-Point Temperatures
1. Press and hold
the display.
2. Press the desired product button and the LED above the
button is on and the set-point temperature flashes.
3. Press the
hold
4. Once the
seconds.
5. To reset set-point temperature to default settings, press and hold
both
To change Product Cooking Times
1. Press and hold
the display.
2. Press the desired product button and the LED above the button
is on and the set-point temperature flashes.
3. Press
4. Press the
5. Once the
6. To reset cooking time to default settings, press and hold both
simultaneously.
until "PROG MODE" shows in
to change the set-point temperature. Press and
and the values increases by 5.
are released, the set-point is saved after 2
simultaneously.
until "PROG MODE" shows in
and the cook time flashes.
to change the product cooking time.
are released, the time is saved after 2 seconds
Model 500/600
1207