13/ If Operating Abnormalities Occur - Samsung D148W User Manual

EN

13/ IF OPERATING ABNORMALITIES OCCUR

• SUMMARY OF THE FAULTS
d01: water supply fault (tap)
d02: draining fault
d03: heating fault
d04: temperature fault
d05: fault – motor under load
d06: fault - motor overload
Tip:
If one of the above faults occurs and you need to call a repair man, remember to tell him
the message displayed (d01, d02..) as this information will help him.
• BEFORE CALLING FOR SERVICE
Problem
The door falls heavily when
opened (integratable model)
The door does not stay horizontal
when open or returns too quickly
(integratable model)
The door catches when closing - Appliance not stable
The upper basket does not stay
in the high position
Small leak around or under the
appliance (move the appliance
to locate the leak)
Small leak at the door
d07: overflow / anti-leak fault
d08: sprinkling distribution fault
d11: pressure sensor fault
d12: filling fault (water inlet detection system)
d13: overheating fault
d14 : installation fault : (incorrect drainage
connection or inadequate flow rate and tap).
Possible auses
C
- Door springs not tensioned
enough to compensate for the
weight of the panel.
- Door springs tensioned too
much.
- No wooden panel.
- Door not centred on the tub
- Poor manipulation (the basket
is being pulled upwards too
quickly)
- Leak from the tap.
- Leak from the appliance.
(Cf. table fault d07).
- Appliance not stable or not level
- Door not centred on the tub.
23
What to do?
- Tighten the two tensioning
screws accessible in the bot-
tom section above the front
feet.
- Loosen the two tensioning
screws accessible in the bot-
tom section above the front
feet.
- Fit a temporary wooden panel
on the appliance and adjust
the springs.
- Adjust the feet.
- Re-centre by adjusting the
rear feet.
- Act more progressively (see
instructions), one side and
then the other.
- Check that a seal is fitted and
retighten the nut.
- Close the water tap and call a
technician.
- Adjust the feet.
- Re-centre by adjusting the rear
feet.