Assembly Instructions; Assembly Step - Sole Fitness F63 Owner's Manual

F63 / F65 ASSEMBLY INSTRUCTIONS
1

ASSEMBLY STEP 1

See Page 10 for Illustration
1. Remove the treadmill from the carton and position it aside on a smooth, level
floor. The rear should be at least 3' from any wall. Do not remove the Velcro
belt until you have removed the plastic wrap and Styrofoam from beneath
the unit. Turning the unit on its side after removing the belt may cause
the unit fold up and cause serious injury!
2
ASSEMBLY STEP 2
1. Install the six Speed Nut Clips (128) on the Frame Base left and right side.
2. Slide the lower handlebar covers (142L & 144R) onto the console masts
(notice orientation).
Slide the Frame Base Caps (62L & 63R) over the Upright tubes (4 & 5).
3.
Connect the Lower Computer Cable (49) to the Middle Computer Cable (50)
on the right side of the unit.
Before attaching the hardware to Step 3, make sure the cables you just connected don't
get pinched in between the steel tubing. If they do, this may cause issues that prevent
the treadmill from operating properly.
F63 / F65 TREADMILL
8
HARDWARE STEP 2
#128. M5 Speed Nut
Clips (6 pcs)