Cli: Establishing Stp Settings - HP 530 Management Manual

N O T E
Wireless Distribution System (WDS) and Spanning Tree Protocol (STP)

CLI: Establishing STP Settings

CLI Commands Used in This Section
Command
[no] stp [hello-time <value>] [forward-delay <value>] [priority
<value>]
show interface ethernet
This STP configuration is available only through the CLI and not through the
Web browser interface.
Using the CLI to Establish STP Settings. The following example config-
ures Spanning Tree Protocol settings for the device. The "no" version of the
command disables STP on the device.
The "hello-time" range is 1–10, the "forward-delay" range is 4–30, and the
bridge "priority" range is 0–65535.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# stp hello-time 10
ProCurve Access Point 530(config)# stp forward-delay 10
ProCurve Access Point 530(config)# stp priority 255
ProCurve Access Point 530(config)#
Special Features
CLI Reference Page
9-166
9-98
8-27