Images Are Fuzzy, Out Of Focus, Or Distorted - Epson EB-1965 User Manual

Problem Solving
Check
Is the correct port selected?
Is the power for the computer or video source turned on?
Are the image signals being output to the projector?
(Only when projecting images from a laptop computer or a
computer with a built-in LCD screen)

Images are fuzzy, out of focus, or distorted

Check
Is Auto H/V-Keystone set to Off?
Is the focus adjusted correctly?
Is the projector at the correct distance?
Is the keystone adjustment value too large?
Has condensation formed on the lens?
Change the image by pressing the [Source Search] button on the remote control or the control panel.
s "Automatically Detect Input Signals and Change the Projected Image (Source Search)"
Turn the power on for the equipment.
If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you need to
change the output to an external destination as well as the computer's own monitor. For some computer models, when
the image signals are output externally, they no longer appear on the LCD monitor or accessory monitor.
If the connection is made while the power of the projector or computer is already turned on, the Fn key (Function key)
that changes the computer's image signal to external output may not work. Turn the power for the computer and the
projector off and then back on again.
s "From Installation to Projection" p.33
s Computer's documentation
Setting it to On enables Auto H/V-Keystone.
s Settings - Keystone - H/V-Keystone - Auto H/V-Keystone
If you are using the projector with this setting off, manually adjust the projected image.
s "Correcting manually" p.39
Turn the focus ring to adjust the focus.
If the focus is not correct, press the [Focus Help] button.
s "Correcting the Focus" p.45
Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.
s "Screen Size and Projection Distance"
Lower the projection angle to reduce the amount of keystone correction.
s "Adjusting the Image Position" p.45
If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.
Remedy
Remedy
p.94
p.141
119
p.34