Hard Disk Operation (Recording / Playback / Time Shift Recording); Configuration; Tv Type; Tv Out - Sharp TU-R252H Operation Manual

Hard Disk Operation (Recording / Playback / Time Shift Recording)

If the Recorder is used in a cold location (a location at low temperature), the drive will only allow live
viewing after power is turned on until the HDD is ready. During this time, the Recorder will not allow
Time Shift Viewing, recording, display of recording lists or playback of recorded programmes. Please
wait until the HDD is ready.

6.2. CONFIGURATION

You can configure the settings of your
DTR. Select Configuration from Setup
menu and press OK to enter this menu.
Press BACK on the remote to exit.

6.2.1. TV TYPE

Digital terrestrial television channels can
broadcast programmes in a widescreen
format which must be output differently to
normal and widescreen TV sets. This
function tells the receiver the screen format
of the TV connected so that broadcasts are
displayed correctly.Highlight the TV Type
line in the Configuration menu and use
"3/4" to select "4:3" if you have a standard TV set connected or "16:9" if it is a widescreen TV. If you
choose "Auto", the TV type will be set automatically according to the broadcasted programme. This
function duplicates the selection made at the time of first installation and can be used if you change
TV sets.

6.2.2. TV OUT

The receiver can output RGB , CVBS and S-Video signal from the TV SCART on the rear panel.
Although the RGB format results in a better quality picture, not all equipment can cope with an RGB
signal.

6.2.3. VCR OUT

This allows you to select CVBS or S-Video output from the VCR SCART socket.The receiver can
output S-Video and CVBS signal from the VCR SCART on th e rear panel.

6.2.4. HDMI RESOLUTION

This receiver can provide HDMI output in 3 different resolutions: 576p, 720p and 1080i from the HDMI
connector on the rear panel. In order to achieve the best picture quality, please check the HDMI
resolutions supported by your TV set and select the most appropriate one from this menu.

6.2.5. LOW POWER OPTION

If you select YES, low power mode will be activated. In low power mode the power consumption is
less then 3 W (in standby). The front display will show no time information (in standby). If low power
mode is deactivated, all functions will be reactivated.

6.2.6. FAVOURITE MODE

This function enables or disables the 5 favourite channel list mode by pressing "3/4" . If a favourites
list exists it will switch to the list number selected. If there is no favourite listing, a warning message is
displayed.
26