Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGG 649
Summary of Contents for Zanussi ZGG 649
- Page 1 GAS HOB ZGG 649 INSTRUCTION BOOKLET 35670-8203...
-
Page 2: Important Safety Information
Important Safety Information You MUST read these warnings carefully before installing or using the appliance. Installation This appliance must be installed by qualified When using other electrical appliances, ensure personnel, according to the manufacturer’s the cable does not come into contact with the instructions and to the rules in force. -
Page 3: Table Of Contents
Contents For the Installer For the User Technical Data Description of the Appliance Installation Operation Gas Connection Maintenance Building In and Cleaning Fitting the Hob Something Not to the Worktop Working? Electrical Connection Commissioning Servicing Technical Maintenance Keep this instruction book for future reference and ensure it is passed on to any new owner. -
Page 4: Description Of The Appliance
Description of the Appliance 1. Hob Top 2. Rapid Burner 3. Semi-rapid Burners 4. Auxiliary Burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (rapid) 8. -
Page 5: Operation
Operation This hob is provided with a safety If you use a saucepan which is smaller device, which will stop the gas flow if than the recommended size, the flame the flame accidentally goes off during will spread beyond the bottom of the cooking. -
Page 6: Something Not Working
Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM SOLUTION # There is no spark when lighting the gas $ Check that the unit is plugged in and the electrical supply is switched on $ Check that the RCCB has not tripped (if fitted) -
Page 7: Installation
Installation IMPORTANT This appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas Connection On the end of the shaft (A) , which includes the GJ 1/2"... -
Page 8: Building In
Building In Building over a cupboard or drawer Building over a kitchen unit with oven If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant If the hob is built into a kitchen unit with an oven board below the base of the hob on the underneath, the recess must have the underside of the work surface. -
Page 9: Fitting The Hob To The Worktop
Fitting the hob to the worktop Before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob FO 2108 seeping into the cabinet below. -
Page 10: Commissioning
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. -
Page 11: Servicing
Servicing A: Removal Of Hob Top D: Removal Of Burner 1. Remove the panstands and each burner cap 1. Follow the procedures in Section A. and crown. 2. With the aid of a 12mm spanner loosen off the 2. Lift the hob from off the working top. pipe connection nut. -
Page 12: Technical Maintenance
Technical Maintenance Check at regular intervals the condition and serviceability of the gas connection hose and pressure regulator, if any is fitted; in case of malfunction, do not repair but replace the whole faulty part. To ensure a smooth and safe operation, it is necessary to periodically grease the gas taps.