Page 3
Installation • You must read these instructions. The manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these re- quirements. • To prevent the risks of structural damage or physical injury, installation, connection of the appliance to the power supply and gas system, setting up and mainte- nance must only be done by qualified personnel in...
– Speak to your local authorised facilities for disposal of your appliance. Installation Warning! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Gas Connection Choose fixed connections or use a flexible pipe in stain- less steel in compliance with the regulation in force.
Page 5
Adjustment of minimum level To adjust the minimum level of the burners: 1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the control knob. 4. With a thin screwdriver, adjust the by-pass screw po- sition. If you change from natural gas 20 mbar to liq- uid gas, fully tighten the adjustment screw in.
Page 6
MANUFACTURER: ELECTROLUX ITALIA S.p.A. 30 mm C.so Lino Zanussi, 30 33080 PORCIA (PN) - ITALIA min 20 mm (max 150 mm) 50 cm...
Product description Cooking surface layout Control knobs Symbol Description no gas supply / off position Operation Ignition of the burner Warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware.
Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
• Make sure you position the pan supports correctly after cleaning. • To make burners work correctly, make sure that the arms of the pan supports are in the centre of the burn- • Be very careful when you replace the pan supports to prevent the hob top from damage.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre. If you operated the appliance incorrectly, or the in- stallation was not carried out by a registered engi- MOD.
Appliance class: By-pass diameters Burner Ø By-pass in 1/100 mm Auxiliary Gas burners BURNER Auxiliary burner 0.95 Semi-rapid burner Rapid burner 2.45 Environment concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste.