Refer to your local ZANUSSI domestic refrigerators, freezers and ZANUSSI Service Centre and always insist on fridge/freezers are designed to be used genuine spare parts. specifically for the storage of edible foodstuffs only.
CONSERVATION In the interests of the Environment: When disposing of your old fridge, freezer or fridge/ freezer. Help to keep your country tidy – use authorised disposal sites for your old appliances. For maximum efficiency: Make sure that the appliance is cleaned properly. Make sure that the door is closed properly.
INSTALLATION Warning Before using IF YOU ARE DISCARDING AN OLD Remove all securing tapes. Wash inside the APPLIANCE THAT HAS A LOCK OR CATCH appliance with lukewarm water and bicarbonate of ON THE DOOR, YOU MUST ENSURE THAT IT soda (5 ml to 0.5 litre of water). Do not use soap or IS MADE UNUSABLE TO PREVENT YOUNG detergent as the smell may linger.
The electrical connections A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose WARNING: THIS APPLIANCE MUST BE EARTHED. address is listed in the Customer Care Booklet which accompanies your instruction manual. The manufacturer declines any liability should this safety measure not be observed.
Instructions for totally built-in appliances Door reversibility (Fig. 2) D114 Fig. 2 Right-hand opening Recess dimensions Remove pins (P) and (P1). Height 1780 mm Depth 550 mm Left-hand opening Width 560 mm Remove (P) from both sides and also remove the To ensure adequate ventilation, allow the clearances door.
Page 8
Push appliance into housing until stop strip (A) Apply covers (B) on joint cover lugs and into hinge touches the kitchen unit. holes. Fig. 4 Fig. 7 D339 D023 Open the door and push the appliance against the Position the runners (H) at the top and bottom of side of the kitchen unit opposite to that of appliance the inside of the kitchen unit as shown in Fig.
Page 9
Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly.
YOUR APPLIANCE F A S T F R E E Z A - Thermostat control for fridge and freezer compartments B - Dairy compartment C - Can storage shelves with egg tray D - Drink dispenser E - Can storage shelves F - Bottle storage shelf G - Freezer calendar (recommended storage times for frozen foods) and produce storage card (write on / wipe off card for recording what has been stored in the freezer and when)
OPERATION Setting the temperature The freezer compartment The temperature inside the refrigerator and freezer is The four-star freezer compartment is suitable for regulated by a single thermostat with 6 storage of commercially frozen food and for freezing temperature positions and one «OFF» (O) position. fresh foods.
HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been Keep work surfaces clean and avoid cross removed from many pre-prepared food. This together with contamination by not using the same work the changes in shopping habits to a once-a-week shop, surface or knife, without washing them thoroughly in between.
Fresh food refrigeration Positioning the door shelves To obtain the best performance, do not store warm To permit storage of food packages of various sizes, food or evaporating liquids in the refrigerator; do the door shelves can be adjusted in height. cover or wrap the food, particularly if it has a strong To do this proceed as per Fig.
It is also times and as a result temperature fluctuation may advisable to clean the dispenser thoroughly occur. A Zanussi fridge is designed to cope with any between every filling, using a sterilising solution. changes in temperature but under certain...
Defrosting – Replace the scraper in one of the drawers. – Reconnect the appliance to the mains or reset the Refrigerator thermostat. The refrigerator automatically defrosts every time After letting the appliance run for at least half an the compressor stops. The water is discharged, via hour, replace the previously removed food into the pipe, into a tray located at the back of the the compartment.
Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Zanussi Service Force Centre). Replace the light cover by sliding it into its original position and replacing the screw.
Maintenance Record Card together with an Check that: adhesive label, containing the telephone number of The thermostat setting is not too high (see your local Zanussi Service Centre. The label can be page 11). stuck to the machine or adjacent furniture. Other points to check...
* The appliance has been used for normal domestic meets the standards set by the country to which purposes only, and in accordance with the the product is taken. The Zanussi Company in the manufacturer’s operating and maintenance country concerned will be pleased to advise instructions.