Procedure Of Expansion In Cold Maintenance; Expansion Of Pci Ssd Card - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 3 Component Configuration and Replacement (Add, Remove)
3.4 Expansion of components
"Stop the relevant partition referring to '7.1.2 Powering off Partitions' in the "PRIMEQUEST 2000 series
Installation Manual" (C122-E174).
Procedure after expansion
Start the relevant partition referring to'7.1.1 Powering on Partitions' in the "PRIMEQUEST 2000 series
Installation Manual" (C122-E174).

3.4.2 Procedure of expansion in cold maintenance

This section describes the procedures before and after expansion in cold maintenance.
Procedure before expansion
Stop all the partitions referring to'7.1.2 Powering off Partitions' in the "PRIMEQUEST 2000 series Installation
Manual" (C122-E174).
Procedure after expansion
Start the required partition referring to 7.1.1 Powering on Partitions' in the "PRIMEQUEST 2000 series
Installation Manual" C122-E174).

3.4.3 Expansion of PCI SSD card

This section describes the procedure of expanding the PCI SSD card (PCI Express SSD card 785GB / PCI
SSD card1.2TB).
Note
Hot replacement is not supported in the PCI SSD card. Stop the partition before the addition.
In a RAID configuration (Linux software RAID)
1. Power off the partition.
For details on powering off, see '7.1.2 Powering off Partitions' in the "PRIMEQUEST 2000 series
Installation Manual" (C122-E174).
2. Add the PCI Express card.
3. Power on the partition.
For details on powering on the partition, see '7.1.1 Powering on Partitions' in the "PRIMEQUEST 2000
series Installation Manual" (C122-E174).
4. Set the environment of the added PCI Express card.
Remarks
For details on the environmental setting procedure, see 'PCIe SSD-xx ioMemory VSL x.x.x User Guide for
Linux'. xx is the capacity. x.x.x is the version number.
http://manuals.ts.fujitsu.com/
In a SWAP configuration
1. Power off the partition.
For details on powering off, see '7.1.2 Powering off Partitions' in the "PRIMEQUEST 2000 series
Installation Manual" (C122-E174).
2. Add the PCI Express card.
3. Power on the partition.
For details on powering on the partition, see '7.1.1 Powering on Partitions' in the "PRIMEQUEST 2000
series Installation Manual" (C122-E174).
4. Set the environment of the added PCI Express card.
Remarks
For details on the procedure of setting the environment, see 'PCIe SSD-xx ioMemory VSL x.x.x User Guide
for Linux'. xx is the capacity. x.x.x is the version number.
http://manuals.ts.fujitsu.com/
5. Restart the partition (operating system).
54
C122-E175-02EN