General Control; Volume Control; Crossover Frequency Control; On/Stand-By Button - Sharp CP-SW1000W Operation Manual

General control

To turn the power on
Press the ON/STAND-BY button.
The volume indicator lights up
blue.
If the power does not turn on,
check whether the power lead is
plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button
again.
The STAND-BY indicator lights up
red.
Main unit operation:
Turn volume knob clockwise to increase the volume and anti-
clockwise to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume and the VOL – button
to decrease the volume.
Note:
Do not turn the volume knob manually in reverse direction when
operating it by remote control.
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasise the bass, turn this control towards 80 Hz and increase
the volume.
Notes:
Observe the following to avoid malfunction and sound distortion.
Do not set the volume too high on the audio system. The
subwoofer may be damaged.
(Lights
Before you switch on/off the subwoofer, minimise the volume on
up blue)
the audio system.
If no signal is detected for 20 minutes during power on, the
subwoofer will automatically go to stand-by mode.
(Turns red)

Volume control

Crossover frequency control

Auto power off
CP-SW1000W
ENGLISH
E-8