Installing The Leg Extension Attachment; Assembling Your Bowlerflex T-Bar - Bowflex Ultimate Assembly Manual

Assembling Your BOWFLEX Ultimate Leg Assembly
Step 5: INSTALLING THE LEG EXTENSION ATTACHMENT
Place the leg extension on the end of the rail and tighten
the two small star knobs (Item #68) through the sides of
the leg extension rail bracket and into the rail as shown in
Figure U
Take the leg attachment cables and snap them into the
cable storage clips on the bracket under the seat rail.
Figure U
ASSEMBLING YOUR BOWFLEX T-BAR
Your T-bar was shipped fully assembled with the metal bar
resting in the loops of the nylon strap. If, however, the bar and
the nylon strap separated during shipping, follow these
instructions for reassembly.
The nylon strap has one flat side and one side with several
twists. Lay the nylon strap on a flat surface with the flat
side down, as shown in Figure V.
Lift the strap by the metal rings and hold it in front of you.
Turn the strap completely over with the twisted side down.
Grab the strap in the center with the index finger of one
hand. See Figure W.
Use your index finger and thumb of your free hand to
spread the strap into two loops, as shown in Figure X
Using your free hand, slide the bar through the loops.
Remove your fingers from the loop. The strap should wrap
around the bar evenly and slide loosely and freely around
the bar. See figure Y.
68
Unit appears like
this following this
assembly step
(shown with
optional lat
tower)
BEFORE EACH USE OF THE EQUIPMENT,
CHECK ALL FASTENERS, SNAP HOOKS,
CABLES AND PULLEY FUNCTIONS.
TIGHTEN AND FASTEN AS NEEDED.
CHECK PULLEYS AND CABLES FOR
WEAR AND FUNCTION.
Figure V
Figure X
19
Figure W
Figure Y