Salt; Using Salt; Switching Off Salt Refill Indicator/Water Softening System - Siemens Dishwasher Instructions For Use Manual

Salt

Using salt

Always refill with salt immediately before
switching on the appliance. This ensures
that overrun salt solution is immediately
washed out and does not corrode the
rinsing tank.
Open the screw-type cap of the
compartment
25
Fill the tank with water (only required
when switching on the appliance for
the first time).
Then add salt (not table salt).
The water is displaced and runs out.
As soon as the salt refill indicator
on the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
component
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of 21° dH
(37° fH, 26° Clarke, 3.7 mmol/l). If the water
hardness is over 21° dH, salt must be
used.
.
4
Switching off salt refill
indicator/water softening
system
If the salt refill indicator
(e.g. when using combined detergents
containing salt component), it can be
switched off.
Proceed as described under "Setting
water softening system" and set the
value to .
The water softening system and salt
refill indicator are now switched off.
Warnings
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
To prevent corrosion, always refill with
salt immediately before switching on the
appliance.
en
is impaired
4
7