Optical Display While The Programme Is Running; Remaining Running Time Display; Timer Programming; End Of Programme - Siemens Dishwasher Instructions For Use Manual

en
Optical display while the
programme is running *
* depending on model
While the programme is running,
a light spot shines on the floor under
the appliance door. Do not open the
dishwasher door until the light point
is no longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point
is not visible.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
on the digital display
Release both buttons.
Press programme button A until
the factory set value
on the digital display
To change the setting:
By pressing the C button, you can
switch the function off
Press START button
The set value is saved.
Close the door.

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
16
.
1
until
8
is indicated.
is indicated
.
9
or on .
.
8
.
9

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Open the door.
Switch on ON/OFF switch
Press + button until the digital
6
display jumps to
9
Press + or – button until the
6
displayed time corresponds with
your requirements.
Press START button
programming is activated.
To delete timer programming, press
the + or – button until
6
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
Close the door.

End of programme

The programme has ended when the
value is indicated on the numerical
display .
9
The end of the programme is also
indicated by an acoustic signal.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
The LED for button A flashes and the
digital display displays the factory
setting .
Press programme button A until the
factory set value
the digital display .
.
1
.
, timer
8
.
1
until on
8
is indicated.
is indicated on