Sony FD Trinitron WEGA KV-32FS200 Operating Instructions Manual page 48

Other Information
Problem
Cable stations
don't seem to work
Remote control
does not operate
Cannot change
channels with the
remote control Q
Cannot access -_
other menus when
using the Basic
menu
The remote control D
doesn't work in PIP
mode
There is no window Q
picture or it is just
static
t get the same
program in the
window picture as 0
in the main picture
I cannot get L_
anything but TV
The TV needs to be Q
cleaned
Possible Solutions
.J Make sure Cable is set to On in the Channel Setup menu (page 27).
LI Perform Auto Program to add channels that are not presently in the
memory (page 17).
Press TV (FUNCTION) when operating your TV.
LI Check the orientation of the batteries.
Batteries could be weak. Replace them (page 2).
O Move the TV three to four feet away from fluorescent lights.
Make sure you have not inadvertently switched your TV from the
channel 3 or 4 setting if you are using another device to change channels.
ffyou are using another device to control channels, he sure that you have
pressed the FUNCTION button for that device. For example, if you are
using your VCR to control channels, be sure to press the VCR/DVD
FUNCTION buttons (page 4).
If you use the _:_ button to close the Basic menu, only the Basic menu
appears when you press _:_u again. To access the other menus, select the
Advanced Menu option (page 37).
Press the TV FUNCTION
button. You may have inadvertently pressed
the VCR/DVD FUNCTION button, which changes the PIP buttons to
VCR mode (page 20).
Be sure your PIP window picture is set to a video source/channel that has
a program airing.
You may be tuned to a video input with nothing connected to it. Try
cycling through your video inputs using the yellow PIP TV/VIDEO
button with the red dot (page 21).
Both may be set to the same channel. Try changing channels in either the
main picture or the window picture (page 20).
Your TV may be set up to select all your channels through a cable box.
The cable box will only unscramble one signal at a time, so you cannot
use the PiP feature. If possible, run a direct cable to the VHF/UHF jack
on your TV. This will only work if your cable system provides an
unscrambled signal (page 9).
Be sure that you did not set the video label in the Sctup menu (page 36)
to skip your video inputs, lfa video input has been set to "Skip", it will
be skipped x,,hen pressing the TV/Video buttons fi_r eitller the main or
PIP pictures.
Cle;m the TV '_vitha soft dry cloth. Never use strong solvents such as
thinner or benzine, which might damage the finish of the cabinet.
43