Sanyo TLS-1960P Instruction Manual page 8

RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002
LOCATIONS OF CONTROLS AND INDICATORS
Back Panel (With the RS-485/232C interface board)
AC IN
M
1
VIDEO OUT (video output) jack
2
VIDEO IN (video input) jack
3
AUDIO OUT (audio output) jack
4
AUDIO IN (audio input) jack
5
MIC IN (microphone input) jack
6
REMOTE (remote control input) jack
7
SW OUT (switch output) terminal
8
TIMER OUT (timer recording output) terminal
9
TAPE END OUT (tape end output) terminal
F
CONTROL OUT terminal
G
WARNING OUT (warning output) terminal
œ Signals are output when an alarm, clog detection,
video loss, non-recording or mechanism problem
occurs.
H
COM (common) terminal
I
EXT TIMER IN (external timer trigger input) terminal
ALARM REST IN (alarm recording reset input)
terminal
J
SERIES IN (series recording trigger input) terminal
K
CONTROL IN terminal
L
ALARM IN (alarm trigger input) terminal
1 SHOT IN (single image recording trigger input)
terminal
M
AC power input
English
1 A C 2
B
OPEN COLLECTOR (Max. 1=500mA, 2=50mA)
DC12-24V IN
SEE MANUAL
COM
REMOTE MIC IN
L J H F 8
K I G 9 7 6 5
1
DC power input (TLS-1960P only)
A
DC12-24V IN "–" input terminal
B
Do not use
C
DC12-24V IN "+" input terminal
2
RS-485/232C interface board (sold separately)
D
RS-232C connector (D-sub 9-pin type)
E
RS-485 A connector (RJ-11)
F
RS-485 B connector (RJ-11)
G
TERMINATE switch
NOTES:
œ The above illustration shows the unit when the
RS-485/232C interface board is installed. If no
RS-485/232C interface board is installed, connectors
and switches D through to G do not appear.
œ The terminal may be damaged by a torque of 0.49
N . m (5kg . cm) or more and by using screwdriver with a
tip with a diameter of 6 mm or more.
œ Do not connect the RS-485 A and RS-485 B
connectors to a phone line.
œ The 8, F, J and K terminals can be used to select
the input and output signals. (Refer to "SELECTING
INPUT AND OUTPUT TERMINALS" on page 39.)
œ If using the F and K terminals, multiple VCRs can be
operated by operating a single VCR. (Refer to
"SYNCHRONIZATION CONTROL" on page 41.)
œ Pay attention to the polarity of the DC12-24V input
terminal ("+": red screw, "–" : black screw).
7
D E F G
RS232C A RS485 B
TERMINATE
OFF ON
Do not connect to phone line.
AUDIO VIDEO
IN OUT IN OUT
4 3 2 1