Sanyo TLS-1960P Instruction Manual page 21

RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002
NORMAL RECORDING
Record Pause
Recording can be interrupted temporarily.
1
Press the STILL/PAUSE button during recording.
ø The pause/still indicator "
NOTES:
œ The image appears on-screen but it is not
recorded.
œ If a recording pause continues for 5 minutes or
more, the VCR will switch to stop mode to avoid
damaging the tape.
2
To resume recording, press the REC button, or
press the STILL/PAUSE button again.
Recording Check
The image being recorded can be checked.
1
During recording, press the REC CHECK button.
ø The tape will be rewound and then played back.
The VCR will then return to the previous
recording mode.
NOTE:
œ During recording check operations, recording is
suspended momentarily.
Concerning the Number of Times Tapes
can be Rerecorded on
Depending on the recording speed mode, the tape must
be replaced after a certain number of recording times.
N
" flashes.
Refer to the table below for the maximum number of
times a tape can be recorded on.
Recording speed mode
NOTES:
œ The maximum number of recording times will vary
depending on the location and kind of tape used.
Verify the recording quality and replace the tape when
the quality starts to deteriorate.
The maximum number of recording times indicated
above are based on test tapes (E-180) used by the
company.
œ It is recommended that tape be changed at least as
often as in the above table to provide good picture
quality in the mode above.
20
Maximum number of
(hour mode) recording times
(with a standard grade
3
12
24
48
72
96
120
168
240
360
480
720
960
000
tape)
100
50
50
25
15
10
10
5
5
3
2
1
1
1
English