Cub Cadet 1200 Operator's Manual page 23

ELECTRICAL SYSTEM
CHARGE INDICATOR
Remove the spark plug, always using a spark plugwrench,
after every 100 hours of operation to
check the gap.
This instrument indicates whether the alternator is
charging or the battery is discharging. If it shows
discharge continuously, investigate the cause to
avoid completely discharging the battery and
possible damage to the charging circuit.
CAUTION! To avoid possible injury, be
sure engine is off and cool before making
any adjustments or repairs.
HOUR METER
The I nternational Cub Cadet Tractors are equipped
with an hour meter which is located on the
instrument panel. It indicates the actual hours of
engine operation, enabling the operator to deter-
mine without guesswork, when lubrication, change
of oil or periodic inspections are necessary. It also
provides a means of computing cost of specific
!obs. The hour meter operates whenever the engine
is running or the ignition key is in the "ON"
position.
Be sure the gasket is in good condition. Tighten the
plug 1/2 to 3/4 turns past finger tight.
Replace a defective plug with a new plug. See your
I nternational Harvester dealer for the correct
replacement plug.
SPARK PLUG
LIGHTS
Lights are optional on all models except the
Models 1450 and 1650.
The headlights are sealed-beam units. Refer to
"SPECIFICATIONS" when replacement is
necessary.
To replace the taillight lamp, remove the lens from
the taillight and replace. Refer to
"SPECIFICATIONS".
FUSES (Electric lighting and Electric Power
Take-Off Clutch)
Always use the same capacity fuse for replacement.
Refer to "Specifications". If the lights fail or the
clutch does not engage, check the appropriate fuse.
Checking the spark plug gap.
Set gap at .O25-inch.
NOTE: Remove all dirt from around the spark plug
before removing.
21