Getting Started - Mitsubishi Electric NM-C150SD Installation And Operation Manual

[Figure 8 – IP Setting Utility]

2.8 Getting Started

Once installed apply power to the Network Dome Camera. The Network Dome Camera will
start a configuration sequence.
PRESET No.
PRESET TITLE
or AREA TITLE
INFORMATION
DISPLAY
FUNCTION
UNDER RUNNING
1. MAC Address
2. IP Address
3. Ethernet Adapter
4. Start
FASTRAX II E Vx.xxx
CAMERA TYPE xxxx
WAIT DOME SETTING.
INIT TILT ORGIN SET OK
INIT PAN ORGIN SET OK
INIT CAMERA SET OK
[Figure 9 – Starting Camera OSD on CRT Monitor]
001 PRESET
EMPTY DATA !
T001 DOMEID:0001
W→360.0,090.0
[Figure 10 – OSD Position]
Enter MAC address of the product for IP input.
Enter IP address to use.
In case there are several network cards, select a
card to use for the operation of Dome Network
Camera.
Allocate input IP to the Dome Network Camera to
use. When a completion message appears on "5"
Status window in several seconds or minutes,
input completes its process. You can add
additional IPs to other devices continuously.
- 8 -
CAMERA TITLE
CAMERA ID
PAN & TILT ANGLE
VIEW DIRECTION