Related Manuals for Miele DA 396
Summary of Contents for Miele DA 396
- Page 1 Operating and installation instructions Cooker hoods DA 396 DA 399 GiWOZH To avoid the risk of accidents or damage to this appliance it is to read these instructions before it is installed or used for the first time. M.-Nr. 06 417 570...
- Page 2 ......... . 3 .
- Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
- Page 4 This appliance complies with all Before connecting the appliance to relevant legal safety requirements. the mains supply, make sure that Inappropriate use can, however, the voltage and frequency details given lead to personal injury and damage on the data plate correspond with the to property.
- Page 5 The appliance is only completely isolated from the electricity supply Never use an open flame beneath when: the cooker hood. To avoid the – it is switched off at the wall socket danger of fire, do not flambé or grill and the plug removed, over an open flame under the cooker hood.
- Page 6 Packaging (e.g. cling film, materials. These can be obtained from the Miele Spare Parts department or polystyrene) and plastic wrappings must be kept out of the reach of babies from builders’ merchants.
- Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
- Page 8 If the only way of ensuring adequate ventilation is via an open window, then Before discarding an old a window contact switch should be appliance, switch off and fitted. disconnect it from the power supply. The window contact switch ensures that Cut off and render any plug useless.
- Page 9 The cooker hood works with (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") The air is drawn in and cleaned by the The air is drawn in and cleaned first by grease filters and directed outside. the grease filters and then by a .
- Page 11 To switch on, slide the switch to the required setting. Depending on the intensity of the cooking vapours, levels "1" to "3" are (only for recirculation mode) usually sufficient for normal cooking. For short periods of intensive cooking vapours, e.g. when searing meat, you may wish to select the (special accessory for recirculation "IS".
- Page 12 Stainless steel surfaces can be cleaned well wrung-out soft sponge or cloth. using the Miele E-Cloth, or with a ^ Wipe the surfaces dry using a soft proprietary non-abrasive cleaning cloth. agent designed specifically for use on stainless steel.
- Page 13 (special finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen. ^ To take out the grease filters, release the catch on the filter, lower the filter The controls may suffer 45°, unhook it at the back and...
- Page 14 New filters can be purchased from are facing down towards the hob. your Miele dealer or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data" for the model number of the filter.
- Page 15 ^ First remove the grease filters from the cooker hood. Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the wall socket and the plug is withdrawn, or –...
- Page 16 The shaded area represents the wall or ceiling area for the vent cut-out, and for fitting the connection socket. For recirculation mode, only a connection socket needs to be fitted. C 150 mm, or C 125 mm with reducing collar. DA 396 DA 399...
- Page 17 – 650 mm above gas hobs and cookers, – 650 mm above an open grill from our range. For non-Miele cooking appliances, maintain the safety distance as recommended by the manufacturer in their Installation and Operating instructions. If more than one appliance is fitted...
- Page 19 for use when fitting the tower. for securing the exhaust ducting. for securing the retaining plates to the wall. for exhaust ducting C 125 mm. The screws and plugs are designed for use in solid walls. for fitting into the exhaust socket on For other types of wall construction, the motor unit (for extraction mode alternative suitable fixings will be...
- Page 20 Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as Appliance dimensions and the described on the installation sheet. Warning and Safety instructions at A lever is supplied to assist with the the beginning of this book.
- Page 21 For extra safety it is advisable to install All electrical work should be a residual current device (RCD) with a undertaken by a suitably qualified trip current of 30 mA. and competent person in strict accordance with national and local safety regulations.
- Page 22 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...
- Page 23 If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. (optional extra) In addition to insulating the exhaust ducting, we recommend that a suitable...
- Page 24 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
- Page 25 Weight DA 396....21.6 kg DA 399....24.6 kg...
- Page 28 Alteration rights reserved / 0805 M.-Nr. 06 417 570 / 03 en - GB...