Ringer Setup - Panasonic KX-TCD210G Operating Instructions Manual

TCD210G(e-g).book Page 23 Friday, January 14, 2005 1:42 PM

Ringer setup

Ringer volume
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Ruftoneinstell.", then press
{>}.
5
Select "Ruflautstärke", then press {>}.
6
Press {e} or {v} repeatedly to select the
desired volume.
7
Press {>}.
8
Press {ih}.
Night mode
Night mode allows you to select a block of time
during which the base unit will not ring for outside
calls. This feature is useful for times when you do
not want to be disturbed, for example, while
sleeping. Night mode can be set independently
for the handset (Seite 18) and the base unit.
Set the date and time beforehand (Seite 10).
Setting the start and end time for night mode
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Ruftoneinstell.", then press
{>}.
5
Select "Nachtmodus", then press {>}.
6
Select "Start/Ende", then press {>}.
7
Enter the desired hour and minute you wish
to start this feature by selecting 2 digits for
each.
L If you use 12-hour time entry, select "AM"
or "PM" by pressing {*} repeatedly
before entering the time.
8
Enter the desired hour and minute you wish
to end this feature by selecting 2 digits for
each.
Base Unit Settings
L If you use 12-hour time entry, select "AM"
or "PM" by pressing {*} repeatedly
before entering the time.
9
Press {j/OK}.
10
Press {ih}.
Turning night mode on/off
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Ruftoneinstell.", then press
{>}.
5
Select "Nachtmodus", then press {>}.
6
Select "Ein/Aus", then press {>}.
7
Select "Ein" or "Aus", then press {>}.
8
Press {ih}.
Setting the ring delay for night mode
This setting allows the base unit to ring during
night mode if the caller waits long enough. After
the selected amount of time passes, the base unit
will ring, useful when someone urgently needs to
speak with you.
If you select "Kein Rufsignal", the base unit
will not ring during night mode.
1
Press {j/OK}.
2
Select "Basis-Einstell.", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (Seite 26).
4
Select "Ruftoneinstell.", then press
{>}.
5
Select "Nachtmodus", then press {>}.
6
Select "Rufverzögerung", then press
{>}.
7
Select the desired setting, then press {>}.
8
Press {ih}.
23