Advertisement
Available languages
Available languages
SYMPTOM
POSSIBLE
CAUSE(S)
CORRECTIVE
ACTION
Trigger cap leaks
1.
O-ring damaged
1.
Check and replace damaged O-ring
air
2.
Valve stem, seal or O-rings damaged
2.
Check and replace damaged stem, seal or O-
rings
Cap leaks air
1.
Cap bolts loose
1.
Tighten bolts
2.
Damaged gasket
2.
Check and replace damaged gasket
3.
Damaged O-ring
3.
Check and replace damaged O-ring
Nose leaks air
1.
2.
3.
1.
2.
Tool will not
operate
Tool operates
slowly or loses
power
Tool skips fasteners
or inconsistent
operation
Damaged cylinder O-ring
Damaged bumper
Ram guide damaged
Insufficient air supply
Damaged or worn head valve O-ring or
seal
3.
Damaged head valve spring
4.
Head valve binding in cap
5.
Insufficient
lubrication
1.
Damaged head valve spring
2.
Damaged or worn O-rings
3.
Damaged trigger assembly
4.
Build-up on ram
5.
Cylinder not sealed on bumper
properly
6.
Insufficient air supply
7.
Head valve poorly lubricated
8.
Insufficient
lubrication
1.
Worn or damaged bumper
2.
Build-up on ram or nose
3.
Insufficient air supply
4.
Damaged or worn piston O-ring
5.
Damaged magazine springs
6.
Magazine-nose
bolts loose
7.
Fasteners too short
8.
Damaged fasteners
9.
Incorrect fastener size
10. Cap leaks
11. Damaged trigger valve seal and O-
rings
12. Bent or damaged ram
13. Dirty magazine
14. Damaged or worn magazine
15. Insufficient
lubrication
1.
Check and replace damaged O-ring
2.
Check and replace damaged bumper
3.
Check and replace guide
1.
Check air supply
2.
Replace damaged or worn O-ring or seal
3.
Replace damage spring
4.
Clean and grease cap and head valve
5.
Place five or six drops of air tool oil into inlet cap
1.
Check and replace damaged spring
2.
Check and replace damaged or worn O-rings
3.
Check and replace trigger assembly
4.
Clean piston/ram assembly
5.
Disassemble
cylinder and assemble properly
6.
Check air supply
7.
Disassemble
head valve, clean, grease and
assemble properly
8.
Place five or six drops of air tool oil into inlet cap
1.
Check and replace bumper
2.
Clean and grease piston/ram assembly and inside
of nose cover
3.
Check air supply
4.
Check and replace O-ring
5.
Check and replace springs
6.
Align nose with magazine and tighten bolts
7.
Use only the size and type of fasteners
designated
in the Specifications
list in this manual
8.
Discard damaged fasteners
9.
Use only the size and type of fasteners
designated
in the Specifications
list in this manual
10. Tighten cap bolts. Check and replace damaged
gasket
11. Check and replace damaged seal and O-rings
12. Check and replace damaged piston/ram assembly
13. Clean magazine and lubricate with a dry, film
lubricant.
14. Check and replace magazine
15. Place five or six drops of air tool oil into inlet cap
Advertisement
