User Functions Menu; Reset Alarms; Last Alarm Log; Service Faults - Texecom Premier 412 User Manual

Security control panels with integrated communicator
Hide thumbs Also See for Premier 412:
Table of Contents

Advertisement

Premier 412 & 816 Master User Manual

3. User Functions Menu

This section covers the more advanced functions that
selected users can perform with the alarm system. The
following functions are available:

Reset Alarms

This function is used to reset any standing alarms and
service faults. It is also used to reset detectors with a latched
alarm indication, e.g., Smoke Detectors.
➤ To Reset Alarms, proceed as follows:
1
Enter Access code
Zones
1
2
3
4
5
6
7
8
Alarm
Service
2
Press
Zones
1
2
3
4
5
6
7
8
Alarm
Service
The keypad will bleep and the alarm system will reset
3
all latching detectors and attempt to clear any standing
Alarms

Last Alarm Log

The control panel has a memory that stores the zones that
caused an alarm when the system was last armed.
➤ To view the alarm memory, proceed as follows:
1
Enter Access code
Zones
1
2
3
4
5
6
7
8
Alarm
Service
2
Zones
1
2
3
4
5
6
7
8
Alarm
Service
The keypad will display the zones that caused an alarm
when the system was last armed.
3
Press
to return to the normal disarmed state.
INS141-5
Armed
Ready
Press
Armed
Ready
or

Service Faults

.
Armed
Ready
Press
Armed
Ready
Service Faults
The response to a Service Fault condition is programmed by
the installer but is normally limited to the keypad buzzer. To
silence the Service Fault alarm, enter your Access code.
A flashing Service light indicates a new fault condition. The
alarm system cannot be armed whilst a new fault exists. The
Service light will remain flashing until the new fault is
acknowledged, after which it will revert to a steady yellow
and the alarm system can be armed. The Service light will
remain steady until all faults have been cleared.
AC Fail and Telephone Line Fault can each have a delay
programmed. The Service light will turn steady yellow
immediately on either of these faults but no Service Fault
Alarm (transmission or audible alarm) will occur unless the
delay expires.
If your installer has disabled AC fail acknowledgement
the Service light will flash "rapidly" during an AC fail
condition. The system can be armed without requiring
acknowledgement of this fault.

Acknowledging a New Service Fault

➤ New service faults can be acknowledged as follows:
1
Enter Access code
Zones
1
2
3
4
5
6
7
8
Alarm
Service
2
Zones
1
2
3
4
5
6
7
8
Alarm
Service
The keypad will display all Service Faults.
3
Press
or
to acknowledge the fault and return to
the normal disarmed state.

View Service Faults

➤ Standing faults can be viewed as follows:
1.
Press the
key followed by the
2.
The keypad will display any Service Faults (see
tables on next page).
3.
On completion press the
User Functions Menu
Armed
Ready
Press
Armed
Ready
key.
key.
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Premier 412 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Premier 816Premier 832

Table of Contents

Save PDF