WhisperKool SLIMLINE 2500 Owner's Manual
  1. Manuals
  2. Brands
  3. WhisperKool Manuals
  4. Wine Cooler
  5. Slimline 2500
  6. Owner's manual

WhisperKool SLIMLINE 2500 Owner's Manual

Cooling system
Hide thumbs Also See for SLIMLINE 2500:
Table of Contents

Advertisement

Quick Links

Download this manual See also: System Manual
Enlarged version
SLIMLINE 2500
OWNER'S MANUAL
The Coolest Thing In Wine Storage

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SLIMLINE 2500 and is the answer not in the manual?

Questions and answers

Related Manuals for WhisperKool SLIMLINE 2500

Summary of Contents for WhisperKool SLIMLINE 2500

  • Page 1 SLIMLINE 2500 OWNER’S MANUAL The Coolest Thing In Wine Storage...
  • Page 2 Vinothèque Wine Cellars reserves the right to make corrections or improvements to the information provided and to the related hardware at any time, without notice. Vinothèque and WhisperKOOL are registered trademarks, and ECE is a trademark of Vinothèque Wine Cellars. All rights re- served.

  • Page 3: Table Of Contents

    TABLE OF CONTENTS Quick Reference Guide Unit ........... . . Controller &...

  • Page 4: Quick Reference Guide

    QUICK REFERENCE GUIDE Front / Side View (in cellar / evaporator) Bottle Probe Grille Probe Input Controller Power Cord Drain Port Bottom View Rear / Side View (out of cellar / condenser) Probe Input Power Cord Grille Page 2 SL 091912...

  • Page 5: Controller & Specifications

    QUICK REFERENCE GUIDE Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the feature. Refer to page 15 for complete listing of buttons and symbols. Anti Frost Compressor and Condenser Fan Evaporator Cellar “Pre-Chill”...

  • Page 6: Introduction

    Customer Service Thank you for purchasing a WhisperKOOL Slimline cooling unit. We strive to provide the highest quality products and the best possible customer service. If you have any questions about your WhisperKOOL unit, please call us at 1(800) 343-9463.

  • Page 7: Receiving & Inspecting The Unit

    • Insulation Foam Strips (4) Please leave the WhisperKOOL unit in its original box until you are ready for installation, this will allow you to move the product safely without damaging it. TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.

  • Page 8: Quick Start Guide

    QUICK START GUIDE This guide is meant to serve as a quick reference for installation of the WhisperKOOL unit. The remainder of this Owner’s Manual will provide more detailed information and instructions. Upon receiving the WhisperKOOL unit: 1. Inspect the unit before installation. If damage is found, please contact your distributor or WhisperKOOL Customer Service at 1.800.343.9463 ext 799.

  • Page 9: Preparing The Wine Cellar

    How to Build a Wine Cellar Instructional Video WhisperKOOL has a construction tutorial available on line at our website: www.whisperkool.com. This tutorial will walk you through the steps of constructing a properly built wine cellar and the installation of our WhisperKOOL product line. Wall & Ceiling Framing Build wine cellar walls using standard 2x4 or 2x6 construction methods and ceiling joists following the guidelines of local and state codes in your area.

  • Page 10: Mounting The Unit

    The unit must be mounted within 18“ of the top of the room in order to achieve sufficient cooling. As the room cools down, the warm air will rise to the ceiling. Mounting the WhisperKOOL high in the room will create a consistently cool environment by capturing the warm air and replacing it with cool air.
  • Page 11 Thus the drain line will prevent overflow and leaking by allowing for discharge of the additional condensate. WhisperKOOL carries a condensate pump kit, which allows the excess condensate to be pumped up to 20 ft. away from the unit.

  • Page 12: Pre-Installation

    Electrical Needs The WhisperKOOL System requires a dedicated 110-volt 20-amp circuit. The unit draws a large amount of amps at initial start up. By designating a dedicated circuit breaker, you will guarantee the unit has enough power to run ef- fectively.

  • Page 13: Preparing The Installation Location

    Note: The following installation examples are for reference only, door header construction and framing may vary. When not installing above a door, adequate framing inside of the wall is necessary. WhisperKOOL recommends consulting a licensed contractor for framing and construction needs.

  • Page 14: Installation

    Bottle Probe pre drilled holes. The screws should penetrate the studs and/or frame as well as the upper and lower supports to provide adequate support for the WhisperKOOL system. Power Seal all cracks and gaps around the unit with an air-tight sealant or caulking to prevent air leakage.

  • Page 15: Liquid Measuring Thermostat System

    LIQUID MEASURING THERMOSTAT SYSTEM The WhisperKOOL Slimline cooling unit comes equipped with a liquid temperature measuring thermostat system. The probe contains a sensor chip which actually communicates back and forth to the thermostat. This results in a consistent temperature setting and accuracy.

  • Page 16: System Operation

    SYSTEM OPERATION Initial Start-Up Anti Frost Cycle When power is applied to the unit, the control will The Anti Frost Cycle is a precautionary measure, as briefly display all symbols, and the Compressor icing or frosting of the coil does not occur during symbol will be displayed (if unit is calling for cooling).

  • Page 17: Control Functions

    CONTROL FUNCTIONS Button/Symbol Normal Functions • ON/OFF The ON/OFF button allows the customer the convenience of turning the refrigeration system ON or OFF, from the control panel. This feature does not disconnect power from the unit. In order for the power to be shut off from the unit, the power cord must be unplugged from the wall receptacle.

  • Page 18: Alarm Codes

    SET 1. Press the “Set” button once and it will display the Set Point. After approximately 5 sec- onds, the display will return to normal operation and display the Bottle Probe tempera- ture. 2. Standard Controller - Press and hold the “Set” button for 3-5 seconds until the set point is displayed and the °F symbol starts blinking.
  • Page 19 CPSM Mode Press the “Set” and the “Down Arrow” buttons simultaneously, for 10-15 seconds, and you will access the “Customer Preference Selection Mode” (CPSM). The CPSM allows the customer to “Fine Tune” the Control Operating System to their applicable choice. The following CPSM options are available for adjustment: Fon –...

  • Page 20: Maintenance Schedule

    MAINTENANCE SCHEDULE It is the user’s responsibility to remove any accumulated dust, lint, or other debris from the front and rear intake grilles. This will restrict the airflow and may affect the unit’s ability to function properly. Periodically cleaning the unit’s vents will help assure maximum cooling efficiency.

  • Page 21: Troubleshooting Guide

    TROUBLESHOOTING GUIDE Unit has ice forming on the evaporator Possible Cause Solution Clean coil with a vacuum. Evaporator coil is dirty. If coil is very dirty, use a small hand spray with a small amount of liquid dish washer detergent. Spray coil, let set for 5 min, then flush with fresh water.
  • Page 22 TROUBLESHOOTING GUIDE Unit leaks water Possible Cause Solution Unit is not level Unit should be level in wall to prevent leaking Drain line clogged or kinked Check drain line to make sure water can flow freely. Drain is clogged preventing water form escaping Disconnect drain and clear out Drain line does not have a downward slope Fix Drain line so there is a downward slope from the unit to the drain.

  • Page 23: Technical Assistance & Accessories

    TECHNICAL ASSISTANCE WhisperKOOL Customer Service is available Monday through Friday from 8:00 a.m. to 4:00 p.m. Pacific Time. The customer service representative will be able to assist you with your questions and warranty information more effectively if you provide them with the following: •...

  • Page 24: Installation Terms And Conditions

    Manual are shipped with each unit and, if another copy is needed, replacement copies can be downloaded from the company website (whisperkool.com) or by contacting WhisperKOOL directly for a new copy. WhisperKOOL reserves the right, in its sole discretion, to change its Terms and Conditions at any time, for any reason, without notice.
  • Page 25 10. No one has any authority to add to or vary the limited warranty on this Product. 3. Product Installation Requirements: A. Prior to installing a WhisperKOOL Product, the End User must read the WhisperKOOL Owner’s Manual and thereafter the End User must follow the required installation, use and maintenance procedures set forth by WhisperKOOL in WhisperKOOL’s Owner’s Manual.
  • Page 26 D. End User is responsible for all costs incurred for the installation and/or removal of the Product, or any part thereof, unless such cost has been agreed by WhisperKOOL to be a warranty repair prior to the work being performed.
  • Page 27 E. Correction of Errors and Inaccuracies. These Terms and Conditions may contain typographical errors or other errors or inaccuracies. WhisperKOOL reserves the right to correct any errors, inaccuracies or omissions, and to change or update these Terms and Conditions, at any time without prior notice.
  • Page 28 WhisperKOOL 1738 E. Alpine Ave Stockton, CA 95205 1(800) 343-9463 www.whisperkool.com...

Table of Contents