Petsafe Wireless Pet Containment System Receiver Collar Operating Manual

Hide thumbs

Table Of Contents

PetSafe

Wireless Pet Containment

System

Receiver Collar

Operating Guide

Please read this entire guide before beginning.

Table of Contents

Need help?

Do you have a question about the Wireless Pet Containment System Receiver Collar and is the answer not in the manual?

Questions and answers

Robert Fredrickson

March 11, 2025

Will the "PetSafe Little Dog " receiver (PIG19-11042) work with the older PetSafe **** Containment System transmitter RF-1002?

Summary of Contents for Petsafe Wireless Pet Containment System Receiver Collar

Page 1 PetSafe Wireless Pet Containment ® System Receiver Collar ® Operating Guide Please read this entire guide before beginning.
Page 2: How The System Works
To get the most protection out of your warranty, please register your product within 30 days at www.petsafe.net. By registering and keeping your receipt, you will enjoy the product’s full warranty and should you ever need to call the Customer Care Center, we will be able to help you faster.
Page 3: Prepare The Receiver Collar
To Insert and Remove the Receiver Collar Battery Note: Do not install the battery while the Receiver Collar is on your pet. This Receiver Collar utilizes a replaceable PetSafe battery ® (RFA-67). This unique battery is designed to make battery replacement easier and increase water protection.
Page 4 (RFA-67) can be found at many retailers. Contact the Customer Care Center at 1-800-732-2677 or visit our web site at www.petsafe.net to locate a retailer near you. To Set the Static Correction Level Read all steps before attempting to set the Static Correction Level.
Page 5: Battery Contact Verification
Medium-Low Static Timid or Average Correction 4 Flashes Medium Static Average Energy Correction 5 Flashes Medium-High Static Average or High Correction Energy 6 Flashes High Static Correction High Energy Flashes once every Indicates Low Battery 4 to 5 seconds www.petsafe.net...
Page 6: Fit The Receiver Collar
Fit the Receiver Collar Important: The proper ﬁ t and placement of your Receiver Collar is important for effective training. The Contact Points must have direct contact with your pet’s skin on the underside of his neck. To assure a proper ﬁ t, please follow these steps: Make sure that the battery is not installed in the Receiver Collar.
Page 7 A condition called Pressure Necrosis, which is a devitalization of the skin due to excessive and prolonged contact against the Contact Points, may occur if the steps above are not followed. www.petsafe.net...
Page 8 To Re-Thread the Collar Slide Buckle The slide buckle prevents the collar from becoming loose around your pet’s neck. Ridges The ridges must be facing up; the collar will slip if it is not properly threaded. 1-800-732-2677...
Page 9: Taking Your Pet Out Of The Pet Area
Pet Area only on a leash, only at this place, and only with a person. You may initially need to convince your pet to leave the Pet Area with a food treat and lots of praise. Note: You may also carry your pet out of the Pet Area. www.petsafe.net...
Page 10: Troubleshooting
Troubleshooting The Receiver Collar • The beep may be difﬁ cult to hear in a noisy environment. is not beeping • Use Test Light as explained in the “Test Light Instructions” when setting up the section, and use it to determine the location of Boundary Zone. Boundary Zone.
Page 11 Receiver Collar changes near the Boundary Zone, or if the surrounding “electronic noise” interferes with the signal. If this continues to occur, consider relocating the Transmitter and resetting the Pet Area. • Re-Synchronize the System. (page 14) www.petsafe.net...
Page 12 The Receiver Collar • Make sure the Static Correction Level is set at 2 or above. is beeping but my • Test the Receiver Collar with the Test Light. • If the Test Light ﬂ ashes, check the ﬁ t of the Receiver Collar. pet is not responding •...
Page 13: Test Light Instructions
Test Light ﬂ ashes. Save Test Light for future testing. Note: If the Test Light does not ﬂ ash, install a new battery and re-test. If Test Light still does not ﬂ ash, contact the Customer Care Center at 1-800-732-2677. www.petsafe.net...
Page 14: Re-Synchronize The System
Re-synchronize the System Remove the Receiver Collar from your pet. Remove the battery from the Receiver Collar. Discharge all power by holding the correction level button down until the LED is no longer illuminated. At the transmitter, move the Boundary Switch from the low to the high position. Slowly adjust the Boundary Control Dial up to 8, down to 1 and then back to the #4 position.
Page 15 This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction guide, may cause harmful interference to radio communications. However, there is no guarantee that www.petsafe.net...
Page 16 interference will not occur in a practical installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •...
Page 17: Customer Care International
Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if he is not kept from crossing the boundaries, you should NOT rely solely upon the PetSafe ® Wireless Pet Containment System ®...
Page 18 1-800-732-2677...
Page 19 www.petsafe.net...
Page 20 Radio Systems ® Corporation 10427 Electric Avenue Knoxville, TN 37932 1-800-732-2677 www.petsafe.net Protected by US Patents 6,879,300; 6,921,089; 7,142,167 and D515,027. Other patents pending. 400-1111 ©2006 Radio Systems ® Corporation...

Petsafe Wireless Pet Containment System Receiver Collar Operating Manual

Table of Contents

Need help?

Questions and answers

Related Manuals for Petsafe Wireless Pet Containment System Receiver Collar

Summary of Contents for Petsafe Wireless Pet Containment System Receiver Collar

Table of Contents