Setting Air Purifying Filter; Tips On Saving Energy; Auxiliary Mode - Sharp AY-ZP48LZ Operation Manual

SETTING AIR PURIFYING FIL-
TER
T h e a i r p u r i f y i n g
accessory of this unit. During operation, the
fi lters remove dust and tobacco smoke from the
air and discharges clean air.
1
Take out the air fi lters.
1 Open the open panel.
2 Push the air filters up slightly to unlock
them.
3 Pull the air fi lters down to remove them.
1
2
2 Set the air purifying filter under the
fi lter stoppers located on the air fi lter.
Air purifying fi lter
Air fi lter
3 Reinstall the air fi lters.
1 Reinstall the air fi lters in the original posi-
tions.
2 Close the open panel.
2
1
Precautions:
• The fi lters are sealed in a plastic bag to keep their
dust collection effect.
Do not open the bag until using the filters.
(Otherwise the fi lters life may be reduced.)
• Do not expose the filters to direct sunlight.
(Otherwise they may deteriorate.)
f i l t e r s a r e p a c k e d a s
3
Filter stopper

TIPS ON SAVING ENERGY

Below are some simple ways to save energy.
SET THE PROPER TEMPERATURE
• Setting to higher or lower than necessary
temperature point will result in increased power
consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP THE FILTER CLEAN TO ENSURE THE
MOST EFFICIENT OPERATION
U S E T H E T I M E R O F F F U N C T I O N W H E N
POSSIBLE
TURN OFF THE CIRCUIT BREAKER WHEN THE
UNIT IS NOT USED FOR AN EXTENDED PERIOD
OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.

AUXILIARY MODE

Use this mode when the remote control is not
available.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX button.
• The red OPERATION lamp (
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp (
turn off.
5
) on the unit will
) on the unit will
AUX