Rtc Battery - HP EliteBook 2570p Maintenance And Service Manual

6. Open the computer.
7. Lift the rear edge of the keyboard until the keyboard rests at an angle, and then swing the top
edge of the keyboard up and forward (1) until it rests upside down on the palm rest.
8. Release the zero insertion force (ZIF) connector (2) to which the pointing stick cable is attached,
and then disconnect the pointing stick cable (3) from the system board.
9. Release the ZIF connector (4) to which the keyboard cable is attached, and then disconnect the
keyboard cable (5) from the system board.
10. Remove the keyboard (6).
Reverse this procedure to install the keyboard.

RTC battery

Description
RTC battery (includes cable and double-sided adhesive)
Before removing the RTC battery, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
72 Chapter 4 Removal and replacement procedures
Spare part number
665733-001