Mitsubishi Electric TN810 ATX User Manual page 28

     
               
Minus (-) or F5
Enter
Home or End
Page up or Page down
F9
F10
Caution
The default BIOS settings may not be appropriate for your particular system. Make a note of
the current settings before pressing
menu.
You can at any time get general help about the control keys by pressing the
The help window on the right-hand side of each menu displays help text for the currently-
selected field. It changes as you move the cursor from one field to another.
To reserve interrupts and upper memory block (UMB) regions for ISA expansion cards, go to the
Advanced menu, select PCI Configuration, then select PCI/PNP ISA IRQ Resource
Exclusion or PCI/PNP ISA UMB Region Exclusion as required.
   
Immediately after the first screen, a second screen displays various POST messages such as the
memory test. While this screen is on display, a message at the bottom says: '
enter setup
menu will appear just before booting:
This menu can be used to temporarily use another drive or device to boot your system, for
example a bootable CD-ROM, without having to enter the BIOS setup. Simply use the up and
down arrows to make a selection. This change will not be permanent and the system boot will
revert to the normal BIOS setting the next time you switch on your system.
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION
Select the previous value for the current field.
Make a selection from the menu bar or enter a sub-menu.
Move the cursor to the top or bottom of the current menu.
Move the cursor to the next or previous page of the current menu.
Restore the default settings for the fields on the current menu.
Save the changes you've made and exit from BIOS Setup.
9 or using the Load Setup Defaults option of the Exit
F
'. Even if this message is not displayed, you can press the <ESC> key and this
Boot Menu
1. Diskette Drive
2. Removable Devices
3. Hard Disk Drive
4. ATAPI CD-ROM Drive
5. Network Boot
< Enter Setup>
         
1 key.
F
Press <F2> to
PAGE 28 OF 46