Table of Contents
Advertisement
INTRODUCTION AND DESCRIPTION
1-1 Introduction
We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple, and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
Note:
all references made to right, left, front, rear, top or
bottom are as viewed from the normal operator's
position on the mower.
1-2 Description
The collection system is designed for turf maintenance
where there is a need to collect the grass clippings as
the mower cuts the turf. It is also good for picking up
leaves and twigs in pre-season and post-season clean-
up.
The engine/blower/blade assembly, is mounted on the
right side of the unit. The blower draws grass clippings
from the discharge area of the cutter deck up to the
aluminum container mounted over the rear portion of the
frame. The operator can engage the
engine/blower/blade assembly by starting the engine.
Once the container is full of clippings, the operator can
easily push and raise the lift handle, releasing the
container's rear door and the container will pivot towards
the ground.
Section II
INSTALLATION FOR USE
2-1 Preparation Of Mower
Carefully dismantle wooden shipping crate from around
the components. Cut retaining straps and separate the
parts. The collection system will have various parts
located inside. Remove and sort all parts for easy
identification.
NOTE:
before each step of assembly it will help to study
the exploded drawings on pages 7 and 8.
Remove the (3) bolts (Figure 1) from each side of the
rear of the mower. Keep the bolt, from each side, that
threads through the mower's rear frame. Place the left
lower main frame leg P#(A0511) onto the rear of the
mower and fasten by using (2) 3/8"-16 x 3" HHCS
SECTION I
P#(K1198) and (2) 3/8"-16 flange nuts P#(K1215). Use
the existing bolt removed from the mower to fasten the
front side of the leg. Repeat this step to fasten the right
main frame leg assembly P#(A0514). See Figure 1 for
details.
Figure 1 Left Lower Main
Frame Leg.
2-2 Attaching The Top Main Frame
Assembly
Place the top main frame assembly P#(A0944) (Figure 2)
onto the main frame legs and fasten each side by using
(1) 3/4"-10 x 1-1/2" HHCS P#(K0364), (1) 3/4"-10 nyloc
nut P#(K1433), (1) ½"-13 x 1" HHCS P#(K1231), and (1)
pivot frame handle P#(A1001). The handles are used to
pivot the frame to the rear for mower engine access. Be
sure that the handles are tight and the frame is in the
upright position before each use!
Figure 2 Top Main Frame Assy.
5
Left Lower Main Frame Leg
3/8" x 3" HHCS
Existing Bolt
Top Main Frame Assembly
Pivot Frame Handle
3/4" x 1-1/2" HHCS
Advertisement
Table of Contents
