Assembly Instructions - Diamondback 910Sr Owner's Manual

ASSEMBLY INSTRUCTIONS
1. Unpack the 910Sr from the carton.
Please recycle.
2. Verify the carton contains all parts from
the list.
3. Remove the short section of steel tubing
from the front stabilizer receiver by
removing the two (2) Allen fixing bolts
with the enclosed wrench. Discard this
item.
4. Align the front stabilizer assembly (K) with the receiver mounted to the frame and
loosely install two (2) sets of the Allen bolts and curved washer assemblies (I‐1 &
I‐2) through the frame and into the front stabilizer (K).
5. Loosely install two (2) sets of the Allen bolt and flat washer assemblies (I‐1 & I‐4)
through the underside of the frame receiver and into front stabilizer (K).
6. Repeat these steps for the rear stabilizer (L). Loosely install two (2) sets of Allen
bolt and curved washer assemblies (I‐1 & I‐2), followed by the two (2) sets of Allen
bolt and flat washer assemblies (I‐2 & I‐5).
7. Tighten all eight (8) Allen bolts (I‐1) firmly with the provided Allen wrench to fix
the front and rear stabilizers.
910Sr Owner's Manual
9