Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Dual XPR522
Summary of Contents for Dual XPR522
- Page 1 XPR522 XPR540 XPR SERIES INSTALLATION / OWNER'S MANUAL Mobile Power Amplifiers...
- Page 2 Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your DUAL amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) •...
-
Page 3: Connection Descriptions
Connection Descriptions Note: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used a general guideline only. Power Wire (BAT+) • Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure. - Page 4 Audio Inputs and Controls XPR522 XPR522 XPR522 XPR540 RCA Line Inputs Crossover Frequency Control Speaker Inputs Bass Boost Gain Input Mode Crossover Mode...
-
Page 5: Power And Speaker Connections
Power and Speaker Connections XPR522 XPR522 XPR540 Fuse(s) Ground Connection Speaker Connection(s) Remote Connection +12VDC Battery Connection... -
Page 6: Typical Wire Routing
Make sure to use incorrect fuse could damage the amplifier. the same size power and ground wire. XPR522 30 amp ATO x 1 XPR522 10 awg XPR540 25 amp ATO x 2 XPR540 8 awg... -
Page 7: Speaker Connections
2 Speakers (stereo) Subwoofer (mono) Connect speaker wires observing polarity. The minimum impedance load for the XPR522 or XPR540 is 2 ohms stereo and 4 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage. The... -
Page 8: Configuration/Setup
Configuration/Setup Input level Control The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. • Begin by turning the input level control fully counterclockwise. • Next, turn up the head unit volume control around 3/4 of the way up. -
Page 9: Limited One-Year Warranty
2. If you require service during the the original purchase. warranty period, you must carefully pack the product (preferably in the Dual Electronics Corp. agrees, at our original package) and ship it by prepaid option, during the warranty period, transportation with a copy of the original... -
Page 10: Specifications
Specifications XPR522 Power Output: 150 Watts x 2 channels @ 4 ohms 300 Watts x 2 channels @ 2 ohms 600 Watts x 1 channel @ 4 ohms (bridged) Peak Music Power Output: 600 Watts @ 4 ohms Signal to noise ratio:... -
Page 11: Troubleshooting
Troubleshooting Problem Cause Action +12V wire not connected or incorrect voltage Check connections for proper voltage REM wire not connected or incorrect voltage (11~16VDC) Unit will not turn on (no power LED indicator) GND wire not connected Check connection to ground Fuse(s) blown Replace fuse(s) Speaker wires not connected... - Page 12 Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2013 Dual Electronics Corp. NSA0513-V01...
Need help?
Do you have a question about the XPR522 and is the answer not in the manual?
Questions and answers