Installation; Safety Notices; Installation And Connection Instructions; Installing The Infrared Receiver - Blaupunkt ODA SURROUND Operating And Installation Manual

INSTALLATION

Installation

Safety notices

Please observe the following safety
notices during installation and whilst
making the connections.
- If installation or maintenance is
carried out incorrectly, the vehicle's
electronic systems might mal-
function.
- Disconnect the negative termi-
nal of the battery! When doing so,
please observe the safety notices
provided by the vehicle manufac-
turer.
- When drilling holes, you must
make sure that none of the vehicle
components (e.g. battery, cables,
fuse box) can be damaged in the
process.
- Depending on the vehicle model,
the conditions in your vehicle may
differ from the description provided
here. We do not accept liability for
any damages caused by mistakes
made during installation or when
making connections or for any con-
sequential damages.
Installation and connection
instructions
The amplifier power cable must be fit-
ted with a fuse at a distance no greater
than 30 cm from the battery. The pur-
pose of the fuse is to protect the vehicle
battery in the event of a short circuit
between the power amplifier and the
battery. The amplifier's own fuse only
protects the amplifier and not the ve-
hicle battery.
26
The amplifier must be secured in a sui-
table installation location, e.g. beneath
the seats or in the car boot (Fig. 1).
When choosing an installation location,
you should select one which is dry and
which provides sufficient air circulation
to cool the amplifier. Use cable grom-
mets to protect cables against sharp-
edged holes. Use loudspeakers with
4 ohms impedance (see table and in-
stallation diagram). Observe the maxi-
mum load rating (music power rating).
Do not connect loudspeakers to earth -
only use the correct terminals as indi-
cated. The cross section of the positive
and negative cable must be at least
2
6 mm .

Installing the infrared receiver

Peel off the foil backing from the ad-
hesive pad. Install the infrared recei-
ver in such a way that you always
have a clear view of the receiver.

Installing the control unit holder

Install the control unit holder (using an
adhesive pad or screws) so that the
control unit is always easily accessible,
e.g. on the centre console.
Caution!
The infrared receiver and the control unit
holder must not be installed within the
inflation range of airbags (driver, pas-
senger side, side airbags) or in any po-
sition where they could be struck by the
vehicle occupants' heads or knees!
You must ensure that the vehicle's con-
trols remain easily accessible and that
their correct functioning is not restricted
in any way (gear stick, handbrake, etc.)!