Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Siemens Extractor hood
Summary of Contents for Siemens Extractor hood
- Page 1 [en] Instructions for installation and use Extractor hood...
-
Page 2: Table Of Contents
Ins truction s for use P roduktinfo Additional information on products, accessories, replacement parts and services can be found at www.siemens-home.com This appliance is labelled in accordance with the and in the online shop www.siemens-eshop.com European Directive 2002/96/EU concerning used Please find the contact data of all countries in the enclosed electrical and electronic appliances (WEEE –... - Page 3 Caution! distance applies. Risk of damage due to ingress of humidity into the electronic The width of the extractor hood must correspond at least ■ circuitry. Never clean operator controls with a wet cloth. with the width of the hob.
-
Page 4: Operating Modes
Increase fan setting by pressing button or reduce Note: Switch on the extractor hood when you start cooking it by pressing button and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen Intensive setting fumes. -
Page 5: Installing And Removing Filter
Installing and removing filter ã= With edge extraction Risk of burns, risk of electric shock! Pull metal-mesh grease filter downwards. from appliance. Always leave appliance to cool down before In doing so, place other hand under the metal-mesh grease cleaning or servicing. Switch off fuse or pull out mains plug. filter. -
Page 6: Replacing Bulbs
Replacing bulbs ã= LED lights Risk of burns, risk of electric shock! Defective LED lights may be replaced by the manufacturer, his from defective bulbs. Switch off fuse or pull out mains plug. customer service or a qualified technician (electrician) only. Always replace defective bulbs immediately (leave bulbs to cool down first) to prevent the remaining bulbs from ã=... -
Page 7: Installation Instructions
Unrestricted operation is possible if the vapour extractor hood air-dependent heat-producing appliance unless an adequate is operated exclusively in the recirculation mode. -
Page 8: Installation
The enclosed screws and wall plugs are suitable for solid ■ brickwork. Suitable fasteners must be used for other structures (e.g. plasterboard, porous concrete, poroton bricks). Installation The max. weight of the extractor hood is 40 kg. ■ ¨ Screw on the fixing bracket for the flue duct. - Page 9 © Screw on brackets for the extractor hood hand-tight, max. 3 Nm. Securing the appliance ® Press the safety caps with the arrow upwards onto ª Screw in threaded pin, leaving it protruding out of the wall the brackets until they engage.
-
Page 10: Attaching Flue Duct
Connecting the pipes Separate the flue ducts. To do this, remove the adhesive tape. Note: If using an aluminium pipe, smooth the connection area Remove the protective foil from both flue ducts. beforehand. Push one flue duct into the other. Exhaust-air pipe Ø... - Page 11 /= /= /= /= /= /= /= /=...
- Page 12 Siemens-Electrogeräte GmbH Carl-Wery-Straße 34 81739 München Germany *9000550704* 9000550704 900731...
Need help?
Do you have a question about the Extractor hood and is the answer not in the manual?
Questions and answers